A perfect foundation for the modern guitarist

The 101 Mini Head provides a rich assortment of boutique-quality tones for home use and recording, coupled with enough power to use on stage. It provides an ideal link between pedals, recording effects, and any good guitar speaker. In many ways, it serves as a good introductory course covering the full range of possibilities inherent in the electric guitar. Despite its small size and streamlined 5-knob control panel, this little powerhouse can also serve as a backup for almost any stage amp.

The high impedance INPUT accepts normal guitar cables. The GAIN control ranges from clean to overdrive. The exclusive TRI-Q control blends three distinct voices, scoop, normal, and lead, providing much more tone shaping than an ordinary “tone” control. The VOICE selector chooses one of five classic overall tonal signatures. The HI-CUT control lets you progressively round off the overall sound of the amp, to match a wide range of speakers. The MASTER control adjusts the overdrive threshold of the amplifier from 0 to 50 watts or more (depending on Voice), offering clean headroom and/or rich overdrive at will. The EFFECTS LOOP provides an ideal place to connect “sweeteners” such as delay or chorus, adding their tone to the overall sound of the amp, including its overdrive. The Effects Send also provides a line-out signal, and the HEADPHONE jack provides private listening as well as an alternate line-level output. Dual SPEAKER jacks on the back drive any normal speaker with a warm, musical response, and the amp is stable with no speaker connected.

REAR PANEL FeaturesINTERNATIONAL POWER SUPPLY

The 101 Mini Head works with all known worldwide AC voltages (100-250V), which allows you to play just about anywhere on the planet.

IEC POWER CORD

Plug the cord that comes with your amplifier into the AC inlet on the rear. Any normal 3-prong IEC cord may also be used with the amplifier. Always ensure that the ground contact is intact on both the cord and receptacle.

SPEAKER OUTPUTS

Connect a single 8 or 16-ohm speaker to the lower jack, marked 8-OHMS.

Connect a single 4-OHM speaker to the upper jack, marked 4-OHMS.

For two 8-ohm speakers, or any other mix of impedances, plug one into each jack. Power will divide between the two speakers. The amplifier will not be bothered by impedance mismatches, so If the tone sounds OK, go for it!

CAUTION: The 101 can provide enough output to burn out low power speakers, especially those built as exact re-issues of vintage 15-30W speakers. For safer results, use the MASTER to select a wattage limit that is equal or less than the speaker being used.

SpecificationsAmplifier Module SpecificationsPower Output:0 to  100 watts maximum, 4-8 ohmsAC Power Req.:100–240Vac, 50–60 Hz, 150 W maximumInput Connections:¼” mono, 2M input impedance, 2V peak.Effects Send:¼” mono, 1V full scale, 600 ohms.Effects Return:¼” mono, 1V full scale, 47KHeadphone Output:3.5mm mini jack, 4V peak.Speaker 1 Output:8 ohms, 60-100 W recommended ratingSpeaker 2 Output:4 ohms, 60-100 W recommended ratingDual Speakers 1+2:8 ohms each, 30-50W recommended rating.DIMENSIONSH x W x D (with feet):3.15” (80 mm) x 8.5” (216mm) x 5.8” (147mm)Weight:2.5 lbs (1.1kg)

www notjustguitars it