The Fundamental Reverb provides you with the core sounds of ambient effects. With 3 reverb algorithms, you can go from ambients hall to an analog spring emulation, as well as a bright plate emulation.

Time: Control the amount of reverb decay time. Left is minimum and right is maximum.
Feedback: Control the amount of wet reverberated signal that is fed back into the signal.
Mix: Control the mix of the effect and the original clean signal. All the way to the left is fully clean, and all the way to the right is fully Reverb.
Slide Switch – The slide switch allows you to change between 3 distinct Reverb algorithms.

• Hall – Emulates the large sounds of an acoustic hall.
• Spring – Emulates spring reverb commonly found in tube amps.
• Plate – Emulates a smooth analog plate reverb

Bypass Switch – Turns the effect on and off
Bypass LED - Illuminated when the effect is engaged.
Trails Modes – Hold down the stomp switch when applying power to the pedal.
Input Jack - 1/4 inch cable from the instrument.
Output Jack - 1/4 inch cable to amplifier.
9v Jack – 9-volt DC, Center Negative, 100mA min

Specifications

• The Delay comes in a Black finish with green and off-white ink.
• The diecast enclosure’s exact size is 4.33" x 2.16" x 1.61”.
• Power requirements are 9VDC (100mA minimum).
• The use of an isolated power supply is recommended for powering all Walrus Audio Pedals.
• Daisy chain power supplies are not recommended. Power supply not included.