NLC Frolic 8 Stage Sequencer/Sequential switch

Brand New Build. 2 Year warranty. Black and gold panel with flat top red LEDs. The same high quality jacks used in most commercial euro modules. WQP-518MA jacks direct from the manufacturer.

A super handy and fun module. Very close to the classic CGS sequencer/ switch in 4U with some added twists. I use two for these in my video setup and the density of function is fantastic. Open to offers.

Shipped within 24 hours of payment. Monday Through Saturday.

Thanks for looking!

Info from NLC

"This module is an 8 stage sequencer/sequential switch. The stages can be controlled by CV or by gates and triggers or both. Feel free to run it audio rates and do other things too.

The analogue (CV) input does need some setting up and there are 2 pots for doing this. The one connected to the analogue input jack is an attenuator. For a typical 5V range CV signal, you would probably set it around the mid-point; the input is sensitive to lower amplitude signals (such as some of the outputs from the Sloth modules). The 2nd pot is to give a positive offset to the incoming CV. Most LFO signals range over +/-5V, so this pot will adjust the signal to make it range from 0-10V, and then you would wind back the attenuator to get a nice motion between stages 1 and 8. It is a lot of fun feeding in complex signals, such as two LFO Tri waves mixed. For a Knightrider KIT effect, use a triangle wave and think about the wonderful things the Hoff has done over the years."