5 Kustom KPX112PM

100W wedge monitors

Photo descriptions:

Kustom wedge 01 - front view with flash, note 12" main driver, horn and port

Kustom wedge 02 - front view no flash

Kustom wedge 03 - top view note carry handle and feet

Kustom wedge 04 - bottom view, note hole for stand mount, feet for upright use and bumpers

Kustom wedge 05 - alt bottom view, note feet on two sides for separate position angle options

Kustom wedge 06 - side view position 1 - performer at shallower angle

Kustom wedge 07 - side view position 2 - performer at steeper angle

Kustom wedge 08 - front view of all speakers, note front corner bumpers

Kustom wedge 09 - end panel showing XLR and ¼" input and ¼" line output*, volume control/attenuator - should be matched to accommodate the output level from the board

No known operational issues with the monitors. A few minor cosmetic bumps over the years, b nothing of consequence. Cabinets are very sturdy and well constructed

*We used these with a single XLR or ¼" aux output from the board to the input of speaker#1, then for a shared mix, daisy chained remaining speaker#2 thru speaker#5 with short XLR to ¼ cables. These cables are included if needed.

We also used a dbx Driverack PX for both room auto EQ tuning and auto feedback detection/suppression when needed. It is available separately.