This legendary vintage 1950's - 60's mic is in good working condition. There are expected blemishes and scuffs, a piece on the top is missing, the original cannon connector was swapped to an XLR barrel at some point but works fine...it is wired for low impedance (150 Ohm)....it is an omnidirectional, dynamic mic with an on-off switch.

The Electro-Voice Model 636 is an omni-directional microphone of the dynamic type with only one moving element. The slim styling of the 636 was specifically designed to provide the flexibility and ruggedness required for general public address use. Incorporating the exclusive Electro-Voice Acoustalloy® dia­phragm material, the Model 636 is nearly impervious to extremes of temperature and humidity. The mechanical nesting principle of design by which the internal parts of the microphone are closely fitted one within another results in a mechanical structure that almost completely eliminates damage from mechanical shock.

The 636 is supplied with a built-in blast filter of an acoustically treated wire mesh grille to minimize wind and breath blasts. The case may be swiveled 90° on the microphone stud which is provided with a standard ⅝"-27 thread for mounting the unit on an upright stand.

Specifications

 •Element: Dynamic
 •Frequency Response: Uniform 60 to 13,000 Hz
 •Polar Pattern: Omni-directional
 •Impedance: 150 ohms and high impedance. 150 ohms balanced to ground
 •Output Level, High Impedance: –58 dB (0 dB = 1 volt/dyne/cm²)
 •Output Level, 150-ohm Impedance: –58 dB (0 dB = 1 mw/10 dynes/cm²)
 •EIA Sensitivity Rating: –154 dB
 •Diaphragm: Electro-Voice Acoustalloy®
 •Case Material: Steel
 •Finish: Satin chrome
 •Dimensions: 1⅛" diameter, 10¼" long
 •Net Weight: 15 ounces
 •Switch: On/Off, sliding contact shorts element in “Off” position