Up for grabs is a used (light average wear / light medium relic'd) genuine Gibson PRPC-015 Chrome Bridge Humbucker Cover - BRIDGE pole spacing: 52mm. Top Side has several imperfections which can be seen in many of the pictures.

• This pickup cover - with the type of imperfections that it has on the TOP Side - is a very good choice for putting a Guitar BRIDGE HUMBUCKER Pickup (with 52mm pole spacing) that you want to have a light medium relic'd appearance.

More detail about it's condition are further down in the description.

BRIDGE COVER:  An original OEM replacement or restoration pickup cover that fits perfectly over any bridge position Gibson humbucker, with a measurement of 52 mm between the centers of the outside poles.

• 52mm -- which is 2 and 1/16 inches (slightly over 2 inches).
• Pictures # 7 and # 8 show the ruler measurement of the the 2 and 1/16" pole spacing

This pickup cover was installed on a guitar pickup. But the pickup cover was not soldered on to this pickup and NO wax was added when it was put over / on the pickup. And the pickup that had this cover on it - was then put on a used guitar (that guitar was used kind of frequently - but not gigged out a lot). NO pickup included / NO guitar included.

TOP SIDE: It has several very light and light very short & short hair-line surface scratches. It has a couple of not too light / not too deep of very short dash scratches. It has a few short deeper scratches. It has a coupe of tiny & very small very light & light nicks / dings and a few small deeper nicks / dings. The right half edge of the Low E hole is slightly pushed in and is is a little uneven (meaning the right half does not have a smooth curve) cause by a pole screw pressing down on this area / this edge-- pictures # 13, 14, & 15 shows the top side of the hole & this area -- and picture # 16 shows the bottom side.

Outer Narrow LEFT, RIGHT, UPPER, and LOWER Sides are mostly clean -- but they have a few very light short hair-line surface scratches and / or a few ligth tiny nicks.

The BOTTOM Side (under-side) of the cover: It has some discoloration and some surface cloudiness from how it was manufactured. And It has a few very light / light vertical hair-line scratches. And as I mentioned above - the edge of the Low E hole and the area near the Low E hole have some unevenness.

==

NOTE: There may be a some imperfections that I over looked. Since the cover is made of metal and has chrome finish - there are somethings that appear on it in the pictures (esp in the pics showing the Top Side) - like glares, reflections, cloudiness (mostly from the lighting and / or from the camera's flash).

You can see the condition of the pup cover in the pictures. Feel free to ask for more pictures.

Please message me if you need other  genuine Gibson  parts -- I have a variety of new / packaged and used (conditions vary) genuine Gibson parts.  Little by little - I will be listing them on REVERB - but if you message me - I can arrange to do a transaction.

• Comes from a smoke free and pet free environment.
• Feel free to ask questions.
• I will discount shipping on combined purchases.

• USA Shipping is with USPS (with tracking)
• International Shipping is with First Class Mail International (with tracking).
  

CA Prop 65 Warning!
Everything sold into the state of California contains agents known to the state of California to cause cancer and birth defects,   reproductive harm, or other, as yet unnamed, harm to its citizenry.