The JHS Pedals 3 Series Tape Delay is a simplified throwback to the classic tape delay units. The Mix control lets you control how much clean signal is blended in with the wet (delayed) signal (on the original unit, this was called Echo Volume).
Tape Speed acts as a simulation of the RE-201’s tape motor speeding up and slowing down and determines how short or long the delay effect is. The Repeats control goes from a single repeat to many, reminiscent of a sound being written onto the tape loop with loss of fidelity each time. Finally, when the Flutter toggle is turned on (up position), it replicates the wear & tear to the mechanical parts of a tape machine that happens over time. This causes mild modulation, warble, and flutter sounds in the echo path of the delay that so many players desire.

MIX Controls how much clean signal is blended in with the wet (delayed) signal. Left is more dry signal. Right is more wet signal.

TAPE SPEED Controls the length of delay effect. Left is shorter. Right is longer.

REPEATS Controls how many repeats occur after you play. Left is less. Right is more.

FLUTTER Switch down is standard effect. Switch up introduces a mild modulation reminiscent of vintage units with mechanical wear.

INPUT ¼” jack on the right side of the pedal.

OUTPUT ¼” jack on the left side of the pedal.

POWER Requires 9VDC negative center power and consumes 65mA. Not not use more than 9VDC. You will void your warranty.

Found Sound Australia Pty Ltd.
110 Albert St
Brunswick East, VIC 3057
Australia