Custom Double Decker Pedalboard

This is a custom handmade hardwood double decker pedalboard (Walnut and mahogany). It is wired to accept a standard power cable and power supply. It has three pre-drilled holes that you can either add telecaster type jacks, or just use them as pass-through cable holes like I did. The top level is on hinges to allow easy access to the pedals underneath. There are 2.5” of space between the top deck and the bottom (slightly less where the hinges are located. The bottom deck pulls off for easy cable management. There are already tie-down locations installed, just add zip-ties! there are a few little scrapes and one chip as shown in the pictures. Dimensions are 21.5” wide x 15” deep. If you have any questions please let me know!