Demeter 400D Bass Head and Case

Bought this to try and love it, but all of my shows are ampless now and I already have a small practice amp at home. This is a great amp in excellent condition with a really nice Studio Slips "clamshell" case. Looks and sounds great.

Specs from the Demeter site:
SPECIFICATIONS
Inputs: two instrument level 1/4” jack. One for Active Basses and one for Passive Basses
Tone section: Treble Control: The treble control gives 6 dB of boost or cut at 4 kHz (6dB per octave, shelving type).
Middle Control: The middle give 6dB of boost or cut at 500Hz (wide Q, peaking type).Bass Control: The bass control gives 9dB of boost or cut at a frequency of 80Hz (6dB per octave, shelving type).Presence Control: The presence control gives up to 12dB of boost at a frequency of 4kHz (active type, 6dB per octave).
Mode switch: Dark, is a high frequency cut fattening up your fundamental. Normal, flat operation showing off more overtones. Bright, brings out the overtones on the dullest basses or speakers.
Internal Volume Trimmer: This control is designed to match the output volume of the VTBP-M-800D with the sensitivity of any Bass.
Standard, Studio output: Line level solid state driven 3 pin balanced output selectable Pre or post EQ with gound lift.
Power Amplifier input: line level input for the 400 watt power amplifer +9 dB for full output
Pre-amplifier output: Lets your pre-amp control more power amplifers (Minnie 800D) for any size venue
Power Amp Outputs: Operating at 4 (400w), 8 (250w) or 16 ohm (150w). 1/4” & Speakon
PREAMP SPECIFICATIONS
Input impedance: > 1meg ohm
Output impedance (line): > 1 kohm, (unbalanced)
Minimum load impedance: 10K
Maximum output: + 24dBV
Signal to noise ratio: – 80dB
Frequency response : 10Hz to 40kHz
Tubes: Hand Selected 1-12AX7a
Outputs (preamp): 1/4” unbalanced ,
Operating voltage: 115V or 230V AC
EQ gain : + or – 12 dB
THD : .5%
3 pin XLR Direct out
Power supply: 220V DC
Filament: 6.3 V DC
POWER AMP SPECIFICATIONS
Outputs (power amp): Speakon/1/4” Combo Speaker jacks
Output impedance (power amp): 4 ohm, 8 ohm, 16 ohm
Output Power (power amp): 400 watt RMS @ 4 ohms, 250 watt RMS @ 8 ohms