Schoeps CMIT 5 Shotgun Microphone

Schoeps CMIT5 in stock at Tidepool Audio!

Fast, free shipping!

• unusually low coloration of off-axis sound
• suitable for music recording as well as dialogue
• rotationally symmetrical polar pattern
• even greater immunity to wind noise than a SCHOEPS supercardoid microphone
• very lightweight, robust all-metal housing
  
• The CMIT 5 is Schoeps' shotgun microphone which has set a new standard for highly-directional microphones since its release. The CMIT 5's directionality increases smoothly with higher frequencies, which results in a very balanced sonic character. In addition to this, the microphone's sound level decreases softly yet steadily for off-axis sounds, allowing these to be recorded neutrally as well as reducing the effects of movement during boom operation. The Schoeps CMIT 5 also has a much stronger directionality than one might expect from a microphone of its length. If required, the CMIT5 can also be used for music recordings, for example opera recordings.
• The sound quality of the Schoeps CMIT 5 remains consistent even if the microphone is rotated on its axis, since its directional pattern is the same in both the vertical and horizontal planes.Three pushbutton-activated filters allow the microphone to adapt to the recording situation: Pairs of LEDs next to each pushbutton indicate the status of the filters. Even in darkness the user can read the settings and see that the microphone is operational. The settings are retained when the microphone is switched off.The capsule and amplifier of the CMIT5 are built as a single unit, unlike SCHOEPS Colette series microphones.
• The capsule and amplifier of the CMIT5 are built as a single unit, unlike SCHOEPS Colette series microphones.
• TECHNICAL SPECIFICATIONS Pickup pattern Supercardioid / lobe-shapedFrequency range 40 Hz - 20 kHzSensitivity -35 dB (V/Pa), 18 mV/PaEquivalent noise level (A-weighted) 13 dBEquivalent noise level (CCIR) 24 dBSignal-to-noise ratio (A-weighted) 81 dBMaximum sound pressure level (THD < 0.5 %) 131 dB-SPL (P48)Maximum output voltage  1.3 V (2.5 dBV) with 1 kΩ loadHigh shelf filter  switchable, +5 dB at 10 kHzLow cut filter switchable, 80 Hz, 18 dB/oct.Proximity filter switchable, 300 Hz, 6 dB/oct.Minimum recommended load impedance 1 kΩOutput impedance 50 ΩMaximum cable length > 400 mSCHOEPS RFI Shield YesPowering standard / Valid range P48 / >34 VCurrent consumption  4.4 mA (P48)Common mode rejection ratio (at 1 kHz) > 65 dBOutput  XLR-3M, analog, 1 channelLength 251 mmDiameter 21 mmWeight 95 gColor blue
  
• • High-frequency emphasis (+5 dB at 10 kHz) enhances speech intelligibility, and compensates for high-frequency loss caused by windscreens;
  • A steep low-cut filter (18 dB/oct. below 80 Hz) suppresses wind and boom noise;
  • A gentle low-frequency rolloff (6 dB/oct. below 300 Hz) compensates for proximity effect.
  • Pairs of LEDs next to each pushbutton indicate the status of the filters. Even in darkness the user can read the settings and see that the microphone is operational. The settings are retained when the microphone is switched off.