Walrus Audio Slö Multi Texture Reverb

We are proud to donate a portion of every sale to Guitars4Vets to help provide music lessons to Veterans battling PTSD.

The toggle switch allows three different  reverb modes, Dark (Lower Octave), Rise (Ambient Swell) and Dream  (Latching Pad), while secondary functions on the switch change between  different wave shapes for the modulation on the reverb trail.

Combine deep modulation with long washy trails and experience, the Slö.

ALGORITHMS:

DARK – Add a  lower octave to your reverb trail. Here you'll create deep and  wide atmospheric sounds and channel nightmarish soundscapes. X knob sets  the level of a -1 octave signal that feeds the reverb.

RISE – This  is an auto-swell reverb for beautiful cinematic swells. Don't rush it.  Let it breathe and gently wake up. X knob sets the amount of time it  takes the reverb to swell in after a note is played. Set lower for  shorter rise times and higher for longer rise times.

DREAM – Here  is a lush reverb with a latching pad function. Press the sustain switch  to latch signal. Experiment with the X knob to add vibrato over the pad.  Press sustain again and pad will decrescendo according to where decay  knob is set. X knob sets the depth of vibrato applied to the  reverb trail.

The Slö also features 3 different wave shapes accessible by holding down bypass while switching the algorithm toggle.

SINE – Smooth and even pitch up and down modulation.

WARP – Asymmetric pitch up modulation similar to a warped record.

SINK – Asymmetric pitch down modulation for sinking detune similar to a Bigsby.

MOMENTARY FUNCTIONS:

Bypass: When the switch is  in off position, press and hold to temporarily activate the effect to  add a moment of reverb texture. Releasing the switch turns the effect  off, and fades it out.

Sustain: When pressed, the  decay switch ramps up the reverb trail to maximum creating long dreamy  reverb trail and then ramps back down to the decay knob setting when  released. In the “Dream” algorithm, the sustain switch is latching.  Press it once to capture and sustain the current reverb decay for  extremely long pad-like sounds. Press it again to let the  reverb trail taper off, based on the position of the decay knob.

TRAILS MODE:

The Slö can run in trails or no  trails mode. In trails mode, when you turn the pedal off, the reverb  decay dies off naturally. In no trails mode, the decay is abruptly cut  off when you turn the pedal off. To toggle between either mode, hold  down the bypass switch for 1 second while applying power to the pedal.  Unplug power and repeat to toggle to the other mode.