Smokin' Amp Co. Passive Volume Pedal and FX Loop Volume control

This passive volume control with foot switch has multiple uses, here are a few ways it can benefit you:

1. After you set your amp for your lead tone, find the sweet spot for your clean tone by turning the pedal on and lowering the pedal's volume to your liking. Now you can switch between clean and lead tone at the press of a switch, no more searching for the sweet spot with your guitar's volume control.

2. Connect to your amp FX loop send and return so you can crank your amp but then dial back the output volume with our pedal- high gain at low volume!

3. Control your guitar volume hands free. The large knob can be controlled by your foot if you need to make changes while you play.

4. Use it as a mute switch by turning the volume all the way down.

5. If you switch between guitars with passive and active pickups, attenuate the higher output active pickups with the volume pedal.

A treble bleed is used, so there is no loss of high frequencies, with this pedal. (You may also request no treble bleed)

The 9v power is only needed for the LED, and the pedal works with no power.

Also, the LED can be removed, if you do not need it.

A 100k Audio taper pot is used by default, if you prefer a different value just message me prior to ordering.

**PLEASE ONLY MAKE AN OFFER ($32 PLUS $5.50 SHIPPING) IF YOU WOULD LIKE THE NO SWITCH VERSION, OTHERWISE THE LISTING PRICE IS THE PRICE FOR THE PEDAL WITH A SWITCH.** White enclosure available at no extra cost, just message for this option.Every pedal is hand built using high quality Neutrik jacks and a pro footswitch, then bench tested before shipping.