Guitarists with heavier tastes looking for their next upgrade will find a sturdy solution in the Peavey invective 120 Head and invective 212 Cabinet. This dynamic duo is perfectly suited for each other, helping players achieve the most revered metal sounds, from woody and clean to the most extreme of high gain tones. A tube amp only sounds as good as what's inside, and Peavey's invective.120 delivers quality with four matched JJ 6L6GC output tubes with top-loaded bias test points and adjustment. On the rear panel, players will find paralleled speaker outputs with impedance selector, an MSDI direct output with Level/Tone/Ground Lift, MIDI out/thru, and MIDI footswitch input. The included footswitch has nine presets to further help the player achieve their desired tone. A remote switchable rack loop and effects loop, half-power switch, and two 9VDC at 500mA auxiliary power jacks complete the back panel. On the front panel, players will find even more options and advanced control.

The invective.120 Head has a single input with four key channels
- Clean channel with boost drive and tone
- Clean channel with gain/low/mid/high/post
- Lead/ Crunch channel input with muting gate threshold;
- Lead/Crunch channel with boost level and tone.

All channels, as well as the channel select with bullet LEDs, are remote switchable. Both the Lead and Crunch channels have independent pre- and post-gain controls as well as shared low/mid/high EQ. The standby and power switches with blue jeweled pilot light indicate when the amp is ready. Just adjust the Master Resonance, Presence and Volume knobs, and it's ready to rock. invective.120

Front Panel
- Single input
- Clean channel Boost Drive & Tone (remote switchable)
- Clean channel Gain/Low/Mid/High/Post - VERY CLEAN
- Channel select with "bullet" LEDs (remote switchable)
- Lead/Crunch channel input muting Gate Threshold (remote switchable)
- Lead/Crunch channel Boost Level & Tone (remote switchable)
- Independent Pre and Post Gain controls on Lead and Crunch channels
- Shared Low/Mid/High EQ on Lead/Crunch channels
- Master Resonance
- Master Presence
- Master Volume
- Blue Jeweled Pilot Light
- Power and Standby switches

Rear Panel
- MIDI / Footswitch Input
- MIDI Out/Thru
- 2 x 9VDC @ 500mA Auxiliary power jacks
- Rack Loop (remote switchable)
- Effects Loop (remote switchable)
- MSDI Direct Output with Level/Tone/Ground Lift
- Paralleled speaker outputs with Impedance Selector
- Half Power switch
- 4 Matched JJ6L6GC output tubes
- Top-loaded bias test points and adjustment
- Made in USA

Footswitch (included)
- Preset Mode
- Rack Loop / Preset 1
- Effects Loop / Preset 2
- Gate / Preset 3
- MIDI CC4 / Preset 4
- Channel Input Boosts / Preset 5
- Clean / Preset 6
- Crunch / Preset 7
- Lead / Preset 8
- Master Boost / Preset 9

zZounds is an authorized dealer of Peavey products.