This Bose 802 Series II passive loudspeaker was part of a large bulk purchase. It's missing its left cinch ring, and it is dusty and has adhesive residue that appears to be from old tape (duct? gaff?) that's dried on. With a new cinch ring and some cleaning it will look more-presentable. If you already have an 802 Series II system that is either missing a speaker or has a non-functioning speaker, this should help you get back to listening and/or performing. According to Bose, this requires a Bose 802C Series II Systems Controller - which is not part of this sale.

Please look at pictures carefully. Only what is pictured is what is being sold and included. (i.e. 1 speaker with cover, only.)

From the manufacturer:

General Description

The Bose 802 Series II sound components provide a fully modular system designed for high quality reinforcement of voice and music.

Bose 802 Series II loudspeakers work with the 802C Series II systems controller for active equalization of the system. The 802 Series II loudspeaker is preferred for applications requiring a rugged, portable enclosure, but can be used in permanent indoor sound system installations.

The 802C Series II systems controller assures smooth, accurate spectral response across the entire operating range of the 802 Series II loudspeaker. Sharp subsonic and ultrasonic band-limiting filters reduce power waste, stage noise, high-frequency instability, and interference. The systems controller also provides two independent signal channels.

Technical Information

Frequency range: 55Hz – 16kHz

Active equalization (with 802C Series II systems controller) Required

Nominal impedance: 8Ω

Maximum acoustic output: 114dB-SPL average, 123dB-SPL peak

Power handling capacity: 240W continuous pink noise, 55Hz – 16kHz

Recommended amplifier power: 240W minimum, 480W maximum

Sensitivity: Full-range, 91dB-SPL (1W, 1m)

Horizontal beamwidth: 120°

Vertical beamwidth: 100°

Enclosure construction: Mica-reinforced polyethylene copolymer structural foam

Fusing: Built-in 4-ampere quick-acting fuse (replaceable)

Insert locations: Four M8 (8 mm)

Connectors: Two (2) parallel-wired 1⁄4" (6.3 mm) phone jacks and two (2) parallel-wired male XLR connectors

Dimensions: 13" (H) x 20 1⁄2" (W) x12 1⁄2" (D) (33 x 52 x 32 cm)

Weight: 31 lb (14 kg)

Component Description

Each 802 Series II loudspeaker uses eight 41⁄2" full-range drivers mounted in symmetric vertical pairs on a faceted Articulated Array® baffle assembly. The drivers feature low-impedance, edge-wound aluminum voice coils, 12-ounce Ferrite V ceramic magnets, and molded polyester frames. Their advanced cone and motor system give them high linear excursion capability and power output.

Tuned reactive air columns reduce distortion by controlling the cone excursion required to reproduce deep bass frequencies. A built-in directivity control circuit maintains the vertical dispersion pattern through the high-frequency range. It also protects the drivers from high-frequency overload.