Near mint condition with a few light paint scuffs on the top of the unit (see pics). Used only a few times in the studio with a 50W amp (well below the rated 200W) for DI recording. These attenuators are hand-built to order, built one at a time -- extremely high quality and reliability.

Get that cranked amp tone at lower overall volume or use it for DI recording into your DAW with the direct Line Out to get the best amp tone.

[From the Weber Speaker Website] This attenuator has two knobs for tonal control. The main volume is controlled by the large Speaker knob. Then to control the treble, use the Treble Compensation knob. The treble control is always dependent on the main volume control. Be aware that the higher the setting on the main knob, the less the effect of the treble compensation. For instance, if you turn the main knob all the way to 10, you’ll notice very little change in the tone as you turn the treble compensation from one end to the other. The line out signal is dependent on your amplifier settings.

200 watt MASS with a moving voice coil speaker motor for the load. This unit is impedance swamped to protect the output of your tube amp, and may be used with 4, 8, and 16 ohm amps. Includes adjustable Line Out, System Bypass, and Variable Treble Compensation. Volume level is continuously variable to over 50db of attenuation.

Like all Weber attenuators, setting the speaker control to minimum (maximum attenuation), allows the MASS 200 to be used as a dummy load for testing or for DI use.

** This sale includes the Weber Mass 200, 200 W Attenuator only. It weighs 7.5 lbs, so I will pack carefully and double box it for shipping to ensure proper protection in transit.

Message me with any questions -- Thanks for looking!