Roland Juno 106 Recently Serviced/Upgraded:

• 17 NEW SLIDERS installed. Including HPF slider.

• 6 NEW VOICE CHIPS. VOICE CHIP CLONES MADE BY BORISH ELECTRONICS

• Voice Chips & Sliders installation & Calibration done by Borish Electronics in Chicago.

• Fully cleaned and serviced Keybed (keyboard circuit board) and keys cleaned internally

• 20 New Slider knobs from Rosen Sound

• All panel buttons lubricated and cleaned internally.

• Over $800 in new upgrades with receipt in photos or you can contact Borishelectronics.com to verify. I cleaned the keys and lubricated the panel buttons.

This is a $2200 synth with the recent repairs.

- Cosmetic Condition:

• Some spots of rust on front panel as seen in photos. It is not pristine pretty on front panel. Although I have had 4 Juno 106 that looked much nicer but did not sound as good as this one. Most junos have not had all the sliders replaced and the voice chips replaced.

• The tip of the Bender wheel is broken off. The Bender wheel still works. Just the very tip of it is broken off. VERY EASY TO REPLACE AND $20 part to replace. But they are on backorder on Syntar. (Not available to order right now in USA. You can get one from the UK for like 60 bucks with shipping and tariff cost) .

I've done more than enough to get this synth working better than most on reverb.

YOUTUBE OF SYNTH: