Power Bus Board with 5V regulator and noise filtering capacitors for your DIY Eurorack Case

Slim and elegant Eurorack Modular Synthesizer Power Bus Board for use in DIY case. Comes with 1.5A +5V regulator which provides clean 5V rail, optimised for inexpensive +12/-12V power supply. Designed and built by L-Fusion Electronics.

Board features proper Eurorack power sockets with reverse polarity protection, noise filtering capacitors, low impedance wide and short same side traces and heavy duty 6.3mm Spade terminals for use with Faston connectors and thick 1.5mm power cables, extra terminals for daisy chaining various boards with the same power supply as well as led indicators for each rail. 

• Inputs: +12V GND -12V
• Input connectors: Heavy duty 6.3mm Spade terminals
• Daisy chaining: Supported, extra +12V GND -12V Spade terminals
• Size: 26x3 cm
• Nose filtering: Quality electrolytic and ceramic capacitors on each rail
• Minimum load: Sockets for optional +/- 12V load resistors
• Screws: 4 x 2.5mm
• Outputs: 14 standard 16 pin Eurorack power sockets
• Indicators: Led indicators for each rail, 3 in total
• Power regulator: Onboard 5V voltage regulator for +5V rail, up to 1.5A 1%
• Testing: Fully tested before dispatch