Saturnworks 3-Channel Triple Buffer Pedal with Neutrik Jacks - Handcrafted in California

The Saturnworks triple buffer keeps your tone strong and clear.

As your signal travels through yards of cables and pedals it tends to loose its high end and becomes dull. Buffers keep your tone sparkly by converting the guitar's normally weak (high impedance) guitar signals into stronger (low impedance) guitar signals.

The Saturnworks triple buffer triples your buffering pleasure as it is three separate buffers in one with three discreet inputs and three outputs. 

Please note: This pedal can also be set up with one or more of its channels reversed -- meaning the signal would flow left-to-right rather than the standard right-to-left.  This configuration can make it easier to connect to a pedalboard by plugging your guitar and amp into the right side of the pedal and your pedalboard 'send' and 'return' to the left side. If you would like the top, center, or bottom channel(s) reversed, please message us after you check out to request that modification.

This pedal can also be set up for bass. The bass version opens up more lower end frequency range, but doesn't cut any highs. If you would like a bass version, just send a message after you check out requesting a bass setup.

The Saturnworks triple buffer is handcrafted with quality components and features including:

• A solid 4.5" x 2.5" x 1" (1590B size) cast-aluminum enclosure.
• Heavy-duty Neutrik 1/4” TS jacks.
• Buffer circuits with 1M input impedance and <100 ohm output impedance.
• Runs on standard 9v DC center-negative pedal power with around 15mA power draw.
• A top quality Lumberg power jack.
• High quality wire made in the USA.
• A 1-year limited warranty against parts and manufacturing defects. See saturnworkspedals.com for warranty terms and conditions.
• Handcrafted and bench-tested in California, USA.  

Check out saturnworkspedals.com for the full Saturnworks lineup.