Onkyo Integra A 820RS, Fully Functional, 240V

The excellent amplifier with very few marks of wear over the years.Have been professionally serviced, tested, cleaned, and replaced components only that were out of spec. All parts are still original.
You will have the quality of build and sound like a 70s-80s amp, which is only a fraction of what you would pay for a modern one to achieve such a level of sound quality.
You will need a step-down transformer to run it in the UK or Europe. This is not included in the purchase, but I can guide you in purchasing it or supply it for an extra fee. Also, It can be converted to 240V internally for about a 150-170£ extra fee (depending on the amp's power) if you request it.
Feel free to contact me if you have any questions and discuss the price, or have any concerns about which amplifier you choose from those I have in my shop.I provide 5-star friendly customer service with after-sales support.

:
   Description:

The RS series top-of-the-line pre-main amplifier is fully compatible with digital sources by adopting the super turbo system.

In the Super Turbo system, the power transformer, which generates harmful modulation noise components inside the amplifier, is separated from the amplifier purely electrically. This system extends the dynamic dynamic range by 20 dB.
In this system, when a low audio signal of 100 Hz or less is input to the amplifier, noise caused by ± imbalance in the power supply is prevented by using a delta turbo circuit, and noise caused by signal magnitude is prevented by using a turbo filter circuit.

Onkyo's unique super servo integral system is adopted.
This method completely eliminates intermodulation distortion that occurs when the electromotive force induced in the speaker flows into the output stage with a time lag due to external factors such as the sound pressure of other channels.
In addition, servo feedback is applied to the input side from both the + and - sides of the output side of the amplifier, and harmful noise components especially at very low frequencies are cut off, and noise components generated in the impedance accumulated by various resistance components in the ground line are suppressed.

Technical Data:
Rated output (20Hz to 20kHz)120W+120W (AUX→SP Out, 8Ω, both channels driven)

Total harmonic distortion

(20Hz to 20kHz)0.007% (AUX → SP Out, at rated output)
0.005% (AUX → SP Out, at 1/2 output)
0.003% (Phono MM → Rec Out, 3V)
0.01% (Phono MC → Rec Out, 3V)

Intermodulation Distortion 0.004% (AUX → SP Out)

Power Band Width5Hz - 100kHz (IHF・3dB, THD 0.2%)

Damping Factor100 (1kHz, 8Ω)

Frequency ResponsePhono→Rec Out=20Hz～20kHz ±0.2dB(RIAA deviation)
AUX→SP Out=2Hz～100kHz +0 -3dB

Input Sensitivity/Impedance

Phono MM=2.5mV/47kΩ, 100kΩ
Phono High MC=2.5mV/100Ω
Phono MC=150μV/100Ω, 220Ω
CD, Tuner, AUX, Tape Play=150mV/47kΩPhono maximum allowable input
(1kHz/10kHz, 0.05%)Phono MM=300mV/1400mV
Phono High MC=300mV/1400mV
Phono MC=19mV/90mVOutput voltage/impedanceTape Rec=150mV/560Ω
Pre Out=1.5V/600ΩS/N ratio (IHF short)Phono MM=88dB
Phono MC=70dB
CD, Tuner, AUX, Tape Play=100dB

Tone control (Vol -16dB)Bass=±8dB(70Hz)
Treble=±8dB(20kHz)loudness+4dB, +6dB(100Hz)

Subsonic Filter 15Hz, 6dB/octMuting-20dB

power supply AC100V, 50Hz/60Hz

Power consumption 210W (Electrical Appliance and Material Control Law standard)AC

Outlet: unswitched 1 piece (200W)
switched 2 pieces (total 200W)

External dimensions: Width 471 x Height 175 x Depth 431 mm

weight 23kg

Disclaimer:

Although I take every precaution in managing my hi-fi and hi-end products, there is a possibility that small scratches may occur during display and storage. I try to check and describe them as much as possible, but I cannot guarantee that every single part is a genuine product.Additionally, what is depicted in the image is all that is included in the product. Please be sure to check the image, as the current state of the accessories and exterior condition will take precedence. I try to describe the condition of the product, such as scratches, sunburn, and dirt, as much as possible, but I may overlook them. It is not realistic to perfectly describe all of the product conditions.Therefore, please be sure to check the condition of the product in an enlarged image. Scratches, sunburn, dirt, etc., that can be seen in an enlarged image are not a reason for return.In addition, I do not accept returns due to minor scratches, sunburn, dirt, etc., that are difficult to see even in an enlarged image. What is in the image is all that is in the product. Scratches, dirt, defective screws, peeling of glue, etc. on the inside and bottom that are not photographed. Deterioration due to aging. These parts that do not affect the function of the audio equipment are not covered by the warranty.