Bash Audio RM BIV-1 matched pair ribbon microphones #70

complete set:
a matched stereo pair of microphones + shock absorber holders + a special preamp of 2 pcs + (There are stereo pads for these microphones available (+$30 if needed))

Size of the ribbon: 60 mm x 5 mm;

Thickness 2.5 microns;

 Material - 99.95% Pure aluminum;

Material of the fastening contacts is gold.

Pattern: eight;

Sensitivity 2 mV / Pa;

Frequency range: 20-18,000 Hz;

Recommended input impedance:1000 Ohm;

Maximum SPL: 135 dB.

Size: 18 cm x 2.5 cm 

The ones who know what kind of microphone it is will certainly say that a ribbon microphone is a studio microphone. Even though it seems to be not enough of high frequencies, the reality of the transmission of the timbre can not be compared to any other microphone. Many beginner sound engineers do not even know what it is. Although recently almost all firms have in their line-up a "ribbon" pattern.

I would not insist that this is a vocal microphone, rather than instrumental, but it is perfect for the baritone. Using a pop-filter is obligatory! It also sounds very good on strings, winds, percussion, xylophone and as overheads. And guitar amps sound fantastic!!!

A novelty that will allow you to take a fresh look at your microphone park !!!

A portable J-Decor preamp allows you to open up the sound of dynamic microphones.

The sound becomes more rich and saturated, more detailed and clear.

All this happens because of the more correct matching of the resistances - the output microphone and the input receiving device.

As soon as the microphone begins to work in more comfortable conditions, it makes more qualitative and correct sound.

The ability to change gain (6dB, 12dB, 24dB), makes it possible to reduce the noise of your mixer or sound card without twisting the Gain knob on them. So gain

Is being distributed between J-Decor and your audio devices.

This is very useful when you use long cables, the signal on the long cable is already amplified and with less loss.

The device has a three-position switch with which you can select the most advantageous input impedance for your dynamic microphone:

Low - 10 kΩ, Mid - 20 kΩ, High - 30 kΩ.

Position High - gives the strongest color in the lower middle of the spectrum, the bass instruments, the big drum sound well.

THD = 0.01%

Input resistance 10 KΩ, 20 kΩ, 30 kΩ

Frequency range: 20 Hz - 20 kHz

Shielded housing.

Powered by phantom power 48 V