Fuchs Plush Verbrator Reverb & Tube Effects loop Parallel Series 2010s - Brown

Fuchs Plush Verbrator Reverb & Tube Effects loop Parallel Series 2010s - Brown

The Verbrator is a new multipurpose pedal which combines an all-tube effects loop with a studio grade reverb featuring a 32-Khz clock speed for full 16-K audio bandwidth.

The Verbrator is the most innovative Plush pedal offering to date.

It's an effects loop, it's a reverb, it's both!

Features:

• Tube Buffered Reverb & FX Loop (Series or Parallel)
• Reverb Level & Decay
• Send & Return Level
• Series or Parallel Loop SW
• Line or pedal level
• 9V DC/ 20mA
• Internal Converter & Regulator for best matching & clean power

Connections:

• From preamp (input): 250K
• To amp(output): 10K (Tube Buffered)
• To effects (send): 250K 
• From effects(return): 10K (Tube Buffered)

1. AS Reverb Pedal:

Guitar > Verbrator Input (From preamp) - Output (To amp) > Amp Input

2. AS FX Tube Loop:

Amp Send > Verbrator Input (From preamp) - Output (To amp) > Amp Return
To Effet > FX Input FX Outpu > From Effect

Unlike other "tube pedals," the Verbrator power supply features a unique regulated switching technology that takes the incoming 9 volts and converts it up to the optimal high voltage a tube really needs to operate best. In addition, a 6-volt DC regulator provides consistent clean DC power for the tube filament assuring lowest noise and consistent performance despite any changes to incoming line voltage.

The Verbrator can be used as a pedal on a pedal board as a reverb pedal. It features a level control and decay control allowing you to have a short medium or long decay reverb algorithm. It can also be used as a tube buffer to convert an incoming high impedance signal to a low impedance for long cable runs or driving a pedal board. The recovery (gain) stage can be used to boost the level of a guitar or pedal board with a true tube audio stage. It provides a warm sweet utility gain stage with a multitude of uses.

The effects loop portion of the pedal features a unity gain cathode follower to work with any amp that has passive preamp output - power amp input patch jacks, and not a true active effects loop like Ceriatone, Dumble, Bludotone, Brown Note, some Marshall models and others. It has a send level control and high headroom. The return portion of the loop features a high impedance input (250-K) and a low output impedance with its own level control as well. The loop can be run in series or parallel modes, and features a level adjust switch for rack or pedal style effects. This is what a DUMBLEATOR does.

This will allow running a stompbox pedal like a Chorus or Delay in an amp's effects loop without a volume drop or other tone degradation.

9-volt DC adaptor provided. This is a 2amp 9V switching power supply, it will work in any country but it has a USA plug on it so you may need a pin adaptor to plug it into your power jack if you don't have a USA style AC power outlet available.

The Verbrator features a unique window showing the tube. Like all Fuchs pedals, the Verbrator features solid cast aluminum powder coated enclosure with heat cured silk screening, dual sided heavy circuit boards, premium switches and controls, and premium electronic parts throughout.