Custom Double Switch - ABY on steroids - Buffers - Dual mixer - Splitter

For sale a one of a kind small switch designed and hand-made in Poland, operating in 2 modes:

1. - the signal from input B is transmitted separately to the GR output, and another signal from input C is simultaneously transmitted separately to the SY output, or
3. - separate signals from inputs B and C are summed and transmitted to the GR output, and the SY output is mutated.

The signal flows only in one direction. There is no possibility of connecting an instrument to the outputs and transmitting it to the inputs. The inputs are on the right (marked as B and C in the photo), and the outputs are on the left (marked as GR and SY in the photos).

The markings are ordinary stickers. They can be easily removed.

Both inputs have separate transparent buffers with high impedance (approx. 2.3 Mohm) allowing for sending a linear signal further and connecting to them without losing the signal even piezo pickups.

The device will be perfect if you want to connect, for example, a:

- guitar with a separate outputs for magnetic and piezo pickups, or

- a Rickenbacker-style bass signal with a separate outputs for each pickups, or

- Chapman Stick

and send their signals to 2 tracks (or, if necessary), a summed signal to only 1 device connected to the GR output. I had a Chapman Stick with Stickup connected to this switch and I sent a signal from both pickups, either to one multi-effect or separately to two multi-effects. Everything worked without any problems. In the case of direct connection of this switch to two amplifiers, there may be a need for the Ground Switch option in one of them due to potential ground loop conflict.

The device was made for playing, not watching, so it doesn't have any fancy design. A regular aluminum die-cast housing. As I wrote, the stickers on it are easy to remove.

Technically 100% functional. I'm selling it because I ordered a more complicated switch with a choice of 4 different connections.

The switch requires a 9VDC power supply with minus on the tip (typical power supply for Boss effects). No power supply included.

Dimensions of the die-cast housing: 90x35x30 mm.

The photo shows traces of Velcro that was once glued on underneath. I will remove them before shipping.