MKII Waveform Magazine Gateway Oscilloscope Eurorack Modular DIY PCB + Component Kit NO OSCILLOSCOPE incl

THIS AUCTION IS FOR A PCB + COMPONENT KIT WITH NO OSCILLOSCOPE INCLUDED. Again, the oscilloscope itself is not included in this kit. You will need to purchase the oscilloscope separately.
 

YOU WILL NEED TO PURCHASE AN OSCILLOSCOPE. DO A WEB SEARCH FOR "FNIRSI-138 PRO DIGITAL OSCILLOSCOPE". YOU DO NOT NEED THE PROBES OR ANY OF THE OTHER IMPLEMENTS SOMETIMES SOLD WITH THE OSCILLOSCOPE.

IF YOU WANT AN ASSEMBLED VERSION, PLEASE VISIT OUR REVERB STORE. THIS AUCTION COMES WITH THE FACEPLATE, POWER PCB, AND COMPONENTS. AGAIN, NO OSCILLOSCOPE IS INCLUDED.

The Mark II version of the Waveform Gateway Oscilloscope is a perfect beginner to intermediate module build, as the FNIRSI-138 Pro single trace oscilloscope that is used for this project (not included in the kit version) comes fully built and no modifications other than soldering three wires to it are needed. The instructions on how to build this can be found on our Waveform Magazine Build Guide page. The three points on the back of the unit where you solder the connections from the power board are all easily reversible, should you decide to remove it from your rack sometime in the future. You only need to build the included Waveform Power PCB, remove a few screws from the oscilloscope case, wire it up, and you’re good to go. With the lava lamp inspired fade to red light up “W” Waveform logo, and the animated waveforms, the Waveform Gateway Oscilloscope MKII looks sleek, too. Faceplate is gold + copper, and is 14HP.

Visit the Waveform online web shop for more Waveform wares.