Mortimer Fuzz

"Clang clang rattle bing bang..."

A clone of a Death By Audio Octave Clang V1 done with a Pedal PCB board.

Completely analog, highly aggressive pseudo-ring modulation and octave-up fuzz pedal with a specially selected transformer.

It's an analog Octave-Up with a chaotic response that mangles chords and waveforms into discordant, industrial, or sitar-like drone overtones, while tracking fairly cleanly on single-note lines.

It has a pretty big amount of output, so it can push out extreme volume levels that are well past unity gain to overdrive subsequent amp stages.

Controls:

Volume - Controls the master output level, scaling from silent to aggressively loud.

Gain/Intensity - Drive the circuit from rich, harmonic "clang" textures into total abrasive fuzz saturation.

Shape/Tone - Sculpts frequency content hitting the circuit, moving from thick low-end response to sharp, cutting upper registers.

Gorva "soft-click" footswitch, Lumberg Jacks and a Red LED to tell you when it's on!

**PLEASE UNDERSTAND THAT THIS PEDAL WILL ONLY TAKE A STANDARD 9V, NEGATIVE TIP, 2.1 MM AC ADAPTER AS MOST PEDALS DO THESE DAYS. ALL PEDALS ARE THOROUGHLY TESTED USING A PROPER ISOLATED POWER SOURCE. IF YOU HAVE ISSUES HOOKING IT UP WITH WHATEVER EXISTING POWER SUPPLIES YOU CURRENTLY HAVE, IT IS NOT AN ISSUE WITH HOW THE PEDAL WAS MADE AND WILL NOT BE REFUNDED**