JBL LE25 TWEETER RECONE KIT COMPLETE REBUILD COMPONENTS PMR LE25 FINALLY!!!

***********************************SEE MY OTHER LISTINGS!!!*************************************
  FINALLY!!!! I've been wanting to post these for quite a while....

 Up for grabs are these JBL LE25 re-cone kits. Yep, all the parts you need to get an LE25 in as-new condition again!

 *****PRICE IS PER KIT**********
  ****A WORD OF WARNING***-- You may find other kits out there that are pre-assembled..

 There are a couple points against buying pre-assembled components this small..

 1.) As small as these parts are, there can and will be ever so slight differences  in the jig that was used to pre assemble the kit, as compared to your actual tweeter assembly. Even .001" is critical with these. Its BEST to build these piece by piece, in place, in the tweeter frame it is to be used in. Don't waste your money.

 2.) The ones I have seen have sloppy, over sized (and weight) adhesive bonds, that are 1/3 of the way up the front of the cone. (((((((((((((((BLAAAAAAH.)))))))))))))))))) you're spending good money -BE NEAT.

  Each of these kits contain a front ring foam /self adhesive donut, a voice coil with long leads, a tiny little spider assembly, deep profile paper dust cap, and a cone assembly that is 'cupped", with the black edge treatment already applied..

 The first picture is what you receive per purchase, the other pictures are for your reference.

These are EIGHT ohm kits.

  * DUE TO THE NATURE OF LOUDSPEAKER REPAIRS  IT IS ULTIMATELY UP TO THE BUYER TO DETERMINE COMPATIBILITY.
 THEREFORE ALL LOUDSPEAKER COMPONENTS ARE SOLD AS-IS-ELECTRICAL WITHOUT ANY RETURNS REFUNDS GUARANTEES EXCHANGES  OR WARRANTY

 BE SURE you understand this, and are OK with as-is before purchase.

 So, if you have an LE 25 project that you've been wanting to do, then here ya' go!

 ANY questions or concerns- just ask.
  Thanks guys