Saturnworks Amp / Device TS Latching Switch with an Externally Powered LED Replaces the, FS-5L, Red Remote, + more

Need a latching switch for your amp, but your amp's footswitch doesn't have an LED, or you're not sure if your amp provides power for an LED? You're covered. 

The Saturnworks single footswitch amp/device switch replaces the Marshall P801, the Boss FS-5L, the JHS Red Remote -- and a variety of other simple latching applications. This switch also works with any device or application applications that requires a basic TS (mono) on/off (open/ground) latching footswitch.

Unlike basic latching switches, this switch features an externally powered LED. This means you can see at a glance what state your amp or device is in. Not sure if your device provides power for an LED on a remote footswitch? No problem. The external power has you covered. And its extremely low power consumption (around 2mA) means you can daisy chain it from about any other pedal, so that it doesn't use up an extra DC plug.

Please note, if your amp or device provides power for an LED, check out our Saturnworks amp switch with an internally powered LED. If the factory switch has an LED, but has no external power jack, it likely is internally powered. 

Some amps and devices switch the LED on when the circuit is open, while others switch the LED on when the circuit is closed (grounded). Not sure which configuration your amp or devices uses? No problem. The toggle switch lets you change the switching relative to the LED. That ensures that the switching is not backward to the LEDs.

For a demo on how the polarity switch works, check out the attached demo video a customer made of his latching polarity switch and how it helped him to solve his 'problem' with his Orange amp--that with the factory footswitch, the effect is ON when the LED is OFF.  Please note: the customer in the video's switch was a custom layout, but has the same circuitry as the switch in this listing. 

The external power combined with a polarity toggle means that this switch has you covered for most single latching switch applications for which you want to add an LED. 

The Saturnworks latching amp switch features boutique-grade parts and features, including:

• A slim 3.5" x 1.5" (1590A size) cast-aluminum enclosure.
• A high quality footswitch. 
• A heavy duty 1/4" TS Neutrik/Rean jack.
• A passive design means that the switch works without power. The power is only for the LED, which runs on standard (for pedals) 9v DC center-negative power. 
• High quality wire made in the USA.
• Handcrafted and bench-tested in California with US and imported components.
• A one-year limited warranty against parts and manufacturing defects. See saturnworkspedals.com/faq for warranty terms and conditions.

This pedal uses a standard mono (TS) patch cable to connect it to the amp.

Please note: the image in this listing is a stock photo. The graphic and LED on the pedal you receive may or may not match the pedal in the image.

Check out saturnworkspedals.com for the full Saturnworks lineup.