Fresh in from the EBS booth at the 2025 NAMM show comes this REIDMAR 502 amp. This unit was on display only at the booth, so it is basically like new, but due to Reverb's listing regulations we need to list it here as being used and in MINT condition. It comes with the power cable and manual in its original retail box as shown.

EBS breaks new ground with this lightweight bass amp featuring a new Class D power module that truly can handle a 2 Ohm load.

FEATURES

• Type: Analog Preamp, 
  2-ohm D-Class Power Amp
• Built-in Compressor/Limiter
• Extremely Powerful 4-band EQ
• Effects loop
• Character filter.
• Balanced XLR-Out with Pre/Post EQ switch and Ground Lift.
• Line and Headphones Out
• Output Power: 500 W
• amp mounted carrying handle

As the EBS Reidmar 502 can handle 2-ohm loads it can drive two 4-ohm cabinets simultaneously. To our knowledge, it is the first lightweight amp in the 500W-range that truly does that. And it does it with conviction too.

Efficient power handling

Due to EBS clever developed Soft-clip design, the Reidmar 502 makes efficient use of all the power at hand. That means more punch and a lot less compressed sound than with lightweight amplifiers using automatic limiters to prevent clipping. It keeps the bass tone from sounding muddy and preserves the lows solid on higher volumes.

Analog preamp 

The preamp, featuring EBS renowned built-in compressor and a 4-band EQ-section, gives you full control. Use it to bring out anything from a warm nice low end, brilliant highs, and mids that cut through the mix when you need it.