Reverb

Mankind has long known of the amazing properties of reverberant spaces. From the brilliant reflections of the largest concert halls to the splashy depths of your own shower, every space has its own characteristic sound.

The Space Force is our updated take on the sounds of “elsewhere,” and features eight ingenious ways to add some space to your place, whether you're reaching for the stars or just trying to make your world a little bigger.

PLATE: Based on a vintage studio reverb, this simulates the reflective properties of a giant metal plate. We’ve also included a virtual tape pre-delay and adjustable tape flanging modulation.

MOD HALL: Classic 1980s electronic hall reverb with adjustable pitch modulation. We’ve added high and low EQ controls to allow for fine-tuning the reverb tone.

PITCH: Chamber reverb effect with twin adjustable pitch shifters. Each shifter has selectable intervals ranging from a detune effect to an octave. Try with detune or down an octave for a cool textural wash.

SPRING: Surf’s up! Spring reverb effect with multi-wave tube bias type tremolo. We’ve placed the tremolo after the reverb to ensure that it stays juicy no matter how wet you run the springs.

LO-FI: 1990s style electronic reverb with distortion on the reverb trails. Classic “shoegaze” effect, try this with the SAW modulation to simulate whammy bar guitar.

ANALOG: “Electronic” reverb based on an obsolete analog delay chip, these units were often used in karaoke machines and have a distinctive tone. Keep the time knob low for reverb or increase for cascading delay effects.

DYNAMIC: Large cathedral-style reverb with a volume-sensing fade effect. GATE mode will cut off the reverb like ‘80s drums, BLOOM will fade in just the reverb signal, and SWELL fades in both wet and dry for a more intense effect.

ECHOVERB: Room reverb and delay in parallel. Each effect has its own set of controls and is independent. The delay effect works even when the reverb effect is in the HOLD / FREEZE state.

PRESETS THIRTY-TWO built-in presets (four banks of 8) allow you to colour with all the crayons in the box. Hold the Bypass / Preset footswitch to select the next preset, or hold both footswitches for the previous.

EXPRESSION AND RAMPING Seamlessly morph between different knob settings on the fly using the built-in ramp footswitch, expression pedal, footswitch, or MIDI controller.

MULTIJACK Connect an expression pedal, footswitch, or MIDI controller to this jack to add performance control to your pedal.

BYPASS TRAILS The reverb + delay trails are configurable for hard bypass, full trails, or auto trails. In auto trails mode, the reverb will decay normally and then seamlessly ramp to zero volume for the lowest possible operating noise

STEREO INS AND OUTS The input jack is selectable for standard mono or TRS stereo signal input without opening the pedal. The output jacks are usable as either mono, two-cable stereo, or TRS stereo. Connect all your Venture and Leap Series pedals in stereo with TRS cables for a neat and tidy pedalboard!

USB PORT Every Leap Series pedal features a USB port for MIDI control and firmware updates.

Mono or stereo input (TRS)

Mono or stereo output (TRS or dual outputs)

Input Impedance: 1M ohms

Output Impedance: 560 ohms

DC 9V only, 250mA or greater

Requires isolated DC power supply

4.7” x 2.6” x 1.5” H x W x D not including knobs

Eight reverb engines