Roland OP-8

This vintage Roland OP-8 from the early 1980s was used to connect the Jupiter 8 or Juno 60 into the MC-4 sequencer. This unit is in very good cosmetic condition. See pictures. There are a few fingernail looking scuffs on the front panel (see diagonal near CV In4-Gate In3-VCF CV jacks and above Transpose switch), there are two small screw holes on the left top faux wooden panel and some small scuffs on one side. There is a missing screw on the bottom and a very slight imbalance when placed on a flat surface (likely can be remedied by adding a washer under one of the feet). The power cord is not tight within the grommet.

Functionally, I don't have a way to verify it works as intended, it is being sold as-is. I did some tests and I'm happy to answer your questions, if I can. I plugged in a Keystep keyboard's Gate output into each of the Gate Inputs 1-8 and the red LED illuminated. For testing the multis, I again used the Keystep's Gate output to thru each of the Multis to the Gate Input and verified the LEDs illuminated going thru the multis. That's all I could figure out how to test.