Pre-soldered Ready-to-Go Custom Wiring Harness for Squier Bronco Bass | Seymour Duncan SHR-1 Hot Rails Humbucker +3-way Mini-Switch -> Series / Split / Parallel | Full-size CTS Pots + Switchcraft Output Jack

Custom pre-soldered wiring harness for Squier Bronco Bass. High-quality, USA-made components starting with a genuine Seymour Duncan SHR-1 Hot Rails humbucker.

This pickup really shines in the Bronco Bass providing increased output and killer tone! It's wired to a 3-way on/on/on mini-toggle switch for access to additional pickup voicings: Coils-in-Series / Single-Coil / Coils-in-Parallel.

The pots are full-sized CTS pots and the 1/4" output jack is a Switchcraft.

I placed the 3-way mini-toggle strategically between the Tone pot and Output jack to be out of the way of your hand while playing. The cavity is small, but fortunately this switch fits perfectly in the narrow spot between the two pickguard screws.

You will need to drill the small hole in the pickguard for the mini-switch. You don't even have to drill, really. There are countless safe & easy ways create the ~1/8" hole. Many without even using a drill or power tool at all. I would suggest putting a piece of painter's or masking tape over your intended spot for the hole, just to protect the pickguard. I always do that when drilling, then start the drill in reverse to create a small divot for the drill tip so it doesn't try to 'walk' across the surface on me.

Alternatively, this pickup and the components of the harness could be used in almost any guitar or other electric instrument. It's a high-output humbucking guitar pickup after all...

3-way Mini-Toggle Switch Positions:

Down = coils in series humbucking 15.55k Ohms

Middle = single coil active 8.05k Ohms

Up = both coils in parallel humbucking 4.07k Ohms

I ship FAST!! See my feedback for details. Check back often and follow my shop.

Regarding Shipping: Your items will be well-packed and covered by Reverb Safe-Shipping.