Kenton Modular Solo Eurorack MIDI to CV Converter 2010s - Silver

Kenton Modular Solo Eurorack MIDI to CV Converter in Good Condition, Including Power Cable and Mounting Screws. Unit has some cosmetic blemishes but is in 100% working order.

The Modular Solo is the perfect MIDI to CV converter for Eurorack modular users. Featuring the rock-solid tuning stability that Kenton converters are famous for, the Modular Solo also includes four continuously variable auxiliary outputs for controlling other aspects of your modular system; as well as two dedicated clock outputs (which can be set to different division ratios) for keeping everything synched up to MIDI clock.

The CV output can operate at the usual 1V/Oct, or as Hz/Volt or 1.2V/Oct. The scaling and tuning are adjustable, to accommodate any unruly modules you might have. The Gate output can work at several different voltage levels, and can also be set to work a S-trig instead. In addition to this, the MIDI OUT port can be switched to output Sync24, so your vintage Roland equipment can join in as well.

It is 10HP wide, 80mm deep, and includes a 20cm ribbon cable to connect to standard Doepfer-style power supplies.

Features:

·Designed to control all types of mono-synth

·Super-fast response time

·Famous Kenton build quality

·High specification 16 bit D/A converter for main CV for rock-steady pitches

·CV/Gate/Aux/Clock outputs on 3.5mm mono jack sockets (3.5mm to 1/4″ cables are available in our cables section)

·CV & Gate signals can be sent via the ribbon cable to the system bus – selected using jumpers

·MIDI IN socket (5 pin DIN)

·MIDI OUT/THRU (5 pin DIN) socket can be switched to become DIN Sync 24 instead

·Any MIDI channel can be selected

·Switchable for V/oct & Hz/V & 1.2V/oct scaling systems

·Fine tune & scale are software controllable

·Transpose (coarse tune) – up & down 12 semitones

·Adjustable pitchbend range – up to 12 semitones

·Programmable Gate V-trig (up to 10V) or S-trig (with or without pull-up)

·Multiple and single trigger modes

·Note priority selection – newest / lowest / highest

·Old notes are remembered to facilitate trill effects and increase playability

·Portamento – fixed rate or fixed time modes

·Auto Portamento mode selectable (where legato playing turns on Portamento)

·Portamento Controller is selectable (default 65)

·Programmable AUX 1,2,3,4 variable analogue output controllable by any MIDI controller

·2x fully independent clock outputs 5V or 10V selectable

·Programmable LFO – 9 wave shapes including random

·LFO can modulate pitch &/or AUX output

·Separate Controllers for LFO to CV and LFO to AUX

·LFO can be synchronised to MIDI clock

·LFO sync point can be selected

·Key-on can reset LFO

·Clock outputs can independently select from 1 to 12, 24, or 48 clocks per quarter note

·Set-up are stored in non-volatile memory for easy recall

·MIDI monitor mode – for easy MIDI troubleshooting

·MIDI OUT/THRU socket can be switched to become DIN Sync 24

·Portamento – new fixed time mode as well as existing fixed rate

·Auto Portamento mode selectable (where legato playing turns on Portamento)

·LFO sync point can be selected

·LFO to CV controller now has Min, Max and Reset values

·LFO to Aux controller now has Min, Max and Reset values

·Key-on can reset LFO

·All parameters are controllable in real-time by SysEx

·Din sync and clock can be used at the same time as CV and Gate outputs