Vintage Neumann M50a Large Diaphragm Omnidirectional Tube Microphone serial# 210c

17% price drop
This seller is open to offers

Reverb Sellers Are Still Shipping

Most items on Reverb are being shipped within 48 hours. Message this Seller if you have any questions.

Buy With Confidence

Reverb Protection has you covered. We provide a safe community for finding the gear you want.

Buy now, pay later – from 0% APR

As low as $695/month with Affirm monthly payments.

Shipped From
Pro Audio Design
Hanover, MA, United States
Preferred Seller

About This Listing

This beautiful vintage Neumann M50a represents the epitome of tube microphone design. Neumann’s M 50 is an omnidirectional tube mic based on the chassis and amplifier of the multipattern M 49. The primary difference between the two was the innovative capsule used in the M 50.

The M50 used a small omnidirectional transducer mounted on a 4cm-diameter acrylic sphere, such that the diaphragm of the capsule lay flush with the face of the sphere. Because sound flows differently around a sphere than around other surfaces, the microphone’s frequency response is altered by this capsule construction. Specifically, the M50 had a smoothly rising frequency response that looks nearly like a high-shelf EQ set to +5dB above 2500Hz.

The value of this response characteristic is beautifully explained by Stephen Paul in his classic survey of vintage mics:

Stephen Paul

High frequencies roll off as the square of the reciprocal of the distance from the sound source due to frictional effects. This means that the viscosity of the air is sufficient to dissipate sound energy in the form of heat, and as there is less power in the treble range, it suffers the most from this effect. Therefore, when a mic is hung high above an orchestra in the auditorium, a boost in the response above 5 kHz is desirable. Even today, these microphones still make some of the most wonderful orchestral recordings in the world.

Related to the effect of the rising frequency response is the directional characteristic of the microphone. Simply put, the mic — although technically speaking still an “omnidirectional” — is more directional at higher frequencies. Neumann The unique feature of the microphone is its high frequency directivity, similar to that of a pressure gradient type, combined with the linear response at low frequencies, well-known for pressure microphones.

Neumann changed components in the M50 several times during its production run from 1951–1971, although not all of the changes were indicated by a model-number designation. The following details are taken from Martin Schneider’s AES presentation on spherical omni microphones :

M 50, 1951: The first commercial release used a Hiller MSC2 tube and a PVC-diaphragm KK50 capsule. According to Neumann’s Martin Schneider, the PVC material was not well suited to the “extreme mechanical tension” required.

M 50a, 1952: the ‘a’ version indicated a capsule change, from KK50 PVC to an aluminum-diaphragm KK53.

1954: the MSC2 tube was replaced with a Telefunken AC701. (This tube/capsule combination was reproduced in the KM53, a tube omni pencil mic.)

M 50b, 1963: “a negligible change, of resistor power ratings.”

1965: The KK53 capsule was replaced with the Mylar-diaphragm KK83.

M 50c, 1965: the “filament topology” of the amplifier circuit was changed, lowering the self-noise by 4dB.

Anselm Roessler

This microphone was, however, extraordinarily difficult to produe and the rejection rate was enormous, so production was halted in 1971.

The concept of altering an omnidirectional condenser transducer’s frequency response by embedding it into a Perspex sphere originated with the NWDR (Nordwestdeutscher Rundfunk) Laboratory, which was Northwest German Broadcast’s research institute, under the direction of Herbert Großkopf.

Neumann has since released the TLM50, a transformerless interpretation of the spherical-omni-capsule concept.

The M 49 and M 50 shared a case and grille design — the grill employs Neumann’s traditional 3-layer metal mesh with a slanted, flattened face. The only visible exterior difference between the two mics is the color of the “jewel” above the Neumann logo on the body. On the M 50, the bead is white. On the M 49, the bead is red.

This vintage, all original microphone includes a contemporary power supply built by BLUE specifically for this mic. Also includes the mounting yoke, the original wooden box, and a Pelican case for the whole setup.

Tech Notes:  AC701 s/n 7118103 all original components.original a revision circuitry but updated to revision C. all components are original from the era of manufacturing so it is safe to assume that the work was carried out by Neumann themselves or a qualified technician of the era. Blue Power supply warrant extremely low noise floor and reliability. frequency response is flat and thanks to the 3/4" capsule makes this the ideal microphone for classical music recordings and DECCA tree.

This item is sold As-Described

This item is sold As-Described and cannot be returned unless it arrives in a condition different from how it was described or photographed. Items must be returned in original, as-shipped condition with all original packaging.

Product Specs

Listed3 years ago
ConditionExcellent (Used)
Excellent items are almost entirely free from blemishes and other visual defects and have been played or used with the utmost care.learn more

Seller Reviews