This
PCB is the same board used in my Standard Wah. It is based on the 1967
Vox Clyde McCoy, with four trim pots to allow some tweaking of the
sweep. If you're not into tweaking, no problem - the trim pots are set
to the stock Clyde values, so it sounds great straight out of the box. The inductor is hand wound by me, patterned off the one in my favourite original Clyde wah
This board will is a direct replacement for the V847 PCB. It is fitted with a pin header so it plugs into the Vox wiring connector, no soldering required.
Please see my other listing for the alternate version with terminals for hard wiring.
Note: this PCB will not fit the Chinese-made Vox V845 or V847-A.
