I bought a large lot of Vintage and these 2 matching Amps were in there. In this picture, the bottom amp powers on and sounds very nice. The Tape Monitor switch needs to have the spring put back in place. I have Deoxit sprayed each of the pots, and there is no crackling or static. The Top Amp blows the Left channel fuse immediately and could be repaired or used for parts. A rarity to find 2 like this. Cosmetically nicer than the others i have seen listed. I have not taken these apart, Tested values or otherwise had them apart, They are sold As Is and will be Packed and shipped well. International shipping would have to be discussed before. Thanks for looking!
The Pioneer SA-900 has high performance pre-amplifiers and power amplifier stages for large output, an extremely high signal to noise ratio and an accurate equaliser characteristic.
Specifications
Power output: 50 watts per channel into 8Ω (stereo)
Frequency response: 25Hz to 40kHz
Total harmonic distortion: 0.3%
Damping factor: 50
Input sensitivity: 1.9mV (mic), 0.155mV (MC), 3.1mV (MM), 7.1mV (ceramic), 180mV (line)
Signal to noise ratio: 80dB (MM), 95dB (line)
Speaker load impedance: 4Ω to 16Ω
Semiconductors: 2 x FET, 29 x transistors, 7 x diodes
Dimensions: 405 x 140 x 339mm
Weight: 12.3kg