• Dual 8 mode VCF / VCA, dual voltage controlled AD/AR/looping envelope, 16 algorithm stereo FX processorPower consumption:
• • Dual multi-mode filter (ladder, diode, vactrol, state-variable lp/hp/bp and comb) in dual, stereo and serial modes
  • Dual AD/ASR/looping envelope generator that acts as band-limited oscillator when cycling at linear slopes
  • Stereo “Cabin Pressure” processor with different 16 effects: from shimmered halls and reverberations to a spring simulation over tape/ping-pong delays / chorus / distortion / compressor and others.
  • Separate mono modular level output and stereo line level output for direct line recording or driving the headphones.
  • Easy firmware update via Audio.
  • Fully compatible with GatewayT_XP
  • Audio I/O: 48 kHz 16 bit, 32 bits internal processing
• • 230 mA +12V
  • 65 mA -12V
  • 0 mA 5VDimensions:
  • 26 HP
  • 26 mm deep

FAQ:

My Grand Terminal is behaving strangely. Can't change fx or vcf types. Signal is too low or distorted. Press all four knobs at once and hold them for more than 4 seconds. This is a soft reset and brings the module back to the factory settings.

I have small noise in my audio output in a certain cases? Try the following PSU adapter for your modular case: 15V Meanwell GST90A15

How to update. Check the video at Endorphin.es.

How can I replace the panel with other color? Check the merch store and panels replacement guide. Also don’t forget the knobs and buttons.

Rainbow cable pinout. Side red/brown pair of pins always correspond to -12V similar as with typical gray ribbon cable.