EarCandy 4x10 4x12 Stereo Mono Combo guitar or bass speaker cab Wiring Harness & plate No Soldering

The 4X12 Stereo mono Combo Wiring harness

This harness installed correctly, wires four 16 ohm speakers to 4 ohms mono, 8 ohms stereo left and right.

DO NOT USE 8 OHM SPEAKERS WITH THIS HARNESS.

Designed for use with any guitar 4X12 speaker cab.

Many cabs use cheap input jacks with 20 gauge aluminum
strand through the wiring harness of the cab. This harness is 16 gauge
OFC pure copper.

We point to point hand wire and solder every harness with silver solder.
This harness comes with a paper diagram, making re wiring your cab
fast easy. This Harness comes ready to install complete with a small roll of solder with the tab less option.

We use the very best Neutrik brand input jacks.
All EarCandy harness's are built with an extra foot of cable from
the leads to the jacks so you have room to move for an easier install.

All EarCandy harness's are hand soldered with silver solder, tested and shipped with in 24 hours of your order.

If you are not remotely familiar with soldering, the wiring harness with wire tabs installed is a better, safer choice. You will receive the wiring diagram complete with a 6 step check list assembled harness with input jacks installed in the jack plate.

Our Jack plates are shipped without the earcandy logo's due to people taking our wiring harness's and putting them in low quality cabs and fraudulently selling them as earcandy cabs. So please be aware that your wiring harness jack plate will be labeled but will not have the earcandy logo in it.

Thank you!