Frap Tools CGM Creative Mixer Channel

The CGM Creative Mixer is a modular mixing solution for Eurorack modular systems, designed to obtain a flexible setup, providing all the tools you may need in studio and during a live performance, as well as everything you may want to control via CV. It is currently composed of three modules: the Channel, the Group and the Master.

The CGM Channel module manages mono signals via the 3.5 mm input mono jack. It has a main stereo VCA with CV in and attenuator (RED), a direct output post main VCA (pre or post fader), two parallel sends with mono VCA with CV in and attenuator for each send and pre/post fader switch (YELLOW and GREEN), and a PAN control with offset CV and offset pot. This, together with the latching buttons for mute, solo in place, and PFL, manages the incoming signal and distributes it to the Group module.

Width: 6HP
Max Depth: 43mm
Power: 104mA@ +12V , 100mA@ -12V , 0mA@ +5V

Features

• Without any CV applied and all pot at maximum, gain scale, referred to channel input, is:
  
• 7.5 dB on channel direct output
• 4 dB on send output (with 5V CV patched to main VCA)
• 12.5 dB on group output (jumpers allowing output of sum of channels and return)
• 18 dB on master output and 20dB on headphones.
• Frequency response: All system is guaranteed from 10Hz to 40KHz bandwidth within 1dB, measured at +10dBu at master output onto a 1KΩ load.
  
• Harmonic Distortion (THD+N): on a complete system (Channel to group to master) less than 0.3%, measured at 1KHz with output signal of +10 dBu onto 1KΩ load with a 10Hz to 80KHz bandwidth measurement system.
  
• Mono audio input impedance > 25KΩ
  
• CV input impedance 100 KΩ ±10%
  
• Includes power cable (connect only one power cable to each chain of channels + group, that channel will take care of powering all the other channels and the connected group).