The Shure PGXD14/85 is a digital wireless system that includes the PGXD4 wireless receiver, PGXD1 bodypack transmitter, and WL185 lavalier microphone. It's part of Shure's PGX Digital wireless series. Designed to offer tailored wireless solutions for vocalists, guitarists, and presenters, the Shure PGX Digital series combines the trusted legacy of Shure microphones with state of the art, 24-bit digital wireless technology delivering strong, clean RF performance. The result is rock-solid RF wireless audio that sounds like wired, with easy setup and operation. This system includes the WL185 cardioid condenser lavalier mic for general-purpose sound reinforcement applications requiring good rejection of ambient noise. It also includes tie clip and windscreen.

Includes

• PGXD4 receiver
• PGXD1 bodypack transmitter
• WL185 lavalier microphone
• Tie clip
• Power supply
• 2 AA batteries
• Carrying case
• User guide

Features

• Includes PGXD4 receiver, PGXD1 bodypack transmitter, WL185 lavalier mic
• 200' operating range
• Automatic frequency selection
• One-touch sync
• 24-bit/48kHz digital technology for incredibly accurate sound

Specifications

• Operating Range*: 200ft (60m) under typical conditions.
  • *Note: Actual range depends on RF signal absorption, reflection, and interference
• RF Carrier Range:
  • X8: 902–928 MHz
  • X8A: 915–928 MHz
  • X8B: 902–907.5 MHz
  • 915–928 MHz (Note: varies by region)
• Audio Frequency Response (± 2dB): 20 - 20,000 MHz
• System Gain:
  • PGXD2: 0 dB at minimum gain setting, ¼" (6.35mm) connector
  • PGXD2: -12.5 dB at minimum gain setting, XLR output
  • PGXD1: -54.5 dBV/Pa at -10dB gain setting, with SM58 catridge, XLR output
• Total Harmonic Distortion:< 0.02%, A-weighted, typical (Ref. 1 kHz, 6 dB below input clip)
• Dynamic Range: >108 dB (A-weighted)
• Operating Temperature Range*: 0°F (-18°C) to +122°F (+50°C)
  • *Note: battery characteristics may limit this range.

PGXD1 Bodypack Transmitter with WL185 Lavalier Microphone Specifications:

• Audio Input Level:
  • +10 dBV maximum, at minimum gain setting
  • -16 dBVmaximum, at maximum gain setting
• Gain Adjustment Range: 26 dB
• Input Impedance: 1 M ohms
• RF Output Level: 10 mW maximum (dependent on applicable country regulations)
• Dimensions (HxWxD): 4.25" x 2.50" x 0.75" (108 x 64 x 19mm)
• Weight: 4.5 oz (128 g) without batteries
• Housing: Molded polycarbonate case
• Power Requirements: 2 “AA” size
• Battery Life: Up to 10 hours
• PGXD4 Wireless Receiver:
  • Dimensions (HxWxD): 1.6" x 7.125" x 4.1" (40 x 181 x 104 mm)
  • Weight: 10.2 oz (289 g)
  • Housing: ABS
  • Audio Output Level: (ref. ± 38 kHz deviation, 1 kHz tone):
    • XLR connector (into 3,000-Ohm load): -2.5 dBV
    • ¼" connector (into 10,000-Ohm load): +10 dBV
  • Impedance: XLR: 50 Ohms / ¼": 50 Ohms
  • Sensitivity: -102 dBm @ 10-5 BER
  • Image Rejection: >70 dB, typical
  • XLR output (Impedance balanced):
    • Pin 1: Ground (cable shield)
    • Pin 2: Audio
    • Pin 3: No Audio
  • Audio LED:
    • Red: 2 dB below clip
    • Amber: 12 dB below clip
    • Green: 50 dBbelow clip
  • Power Requirements: 12-18 VDC at 150mA, supplied by external power supply
  • Pin Assignments: XLR: 1=ground, 2=hot, 3=cold, ¼" (6.35mm) TRS: Tip=audio, Ring=no audio, Sleeve=ground