ETC LED upgrade/replacement burn base for Source Four lights, quantity of two. Less than 100 hours (estimated) run time, put into service May of 2018. Very good condition, always handled professionally. These are great for indoor applications and warmer weather, however, we do shows here in the north that fall below their minimum operating temp, so we need to sell them. Many available, please contact us for bulk pricing.
ETC S4WRDDG-A Source 4WRD LED Retrofit Specifications:
- Physical:
- Rugged, die cast aluminum construction
- Can be fitted to any Source Four fixture body (not for Source Four Par/nel, Fresnel or jr.)
- Seven segment display for simple DMX setup
- Two button user interface
- Easy mounting with single screw attachment
- Replaces Source Four burner assembly
- IP20 rating for indoor use only
- UL and cUL Listed
- S4WRD: UL1598C
- S4WRDFB: UL1573
- US patents issued and pending
- Three-year warranty
- Electrical:
- 114-125V, 60Hz
- 155 watt draw at full (182 Watt theoretical max. draw)
- 30,000 hour L70 Rating (ETC estimate)
- Life testing under way. Results pending
- DMX in and thru via RJ45 connector
- DMX is not self terminating
- One-meter power cord
- AC and DMX dimmable (see 'Dimming Performance' note)
- Two fixtures per circuit (D20 Module) when using AC dimming (recommended)
- 14 fixtures per non-dim circuit (R20 Module) when using DMX dimming
- Inrush: 30A (First half-cycle) at 120V
- Typical Power Consumption at 120V
- Idle Power / Current:
- DMX Mode: 1.2W/.046A
- AC Mode: 0W
- Full Intensity Power / Current: 155.7W/1.35A
- Optical:
- Tool free field adjustment
- LED lamp consisting of four CREE LED Modules
- LED lamp is fragile and should not be touched
- Two LED arrays to choose from
- 3000K, 80+ CRI output
- 3000K, 90+ CRI output (Gallery version)
- Uses the Source Four ellipsoidal’s existing reflector and optical system
- Thermal:
- 5-40° C (41-104° F) operating range
- Fixture must be above freezing temperatures for one hour before being energized.
- Quiet fan cooling
- Fixture is designed for continuous operation up to 104° F (40°C) ambient temperature and requires free flow of air around fixture housing
- Dimming Performance:
- Source 4WRD LED is capable of being both DMX or line dimmed by a conventional SCR dimmer. In AC dimming mode, performance can vary based on the dimmer used and its control settings. For this reason, AC dimming is best suited for level setting or traditional LED quality dimming situations. When high-performance dimming is required, DMX mode should be used. ETC recommends testing Source 4WRD LED on existing dimmers you may wish to use.
