Saturnworks Micro Amp Device Latching Switch w External Power LED Replaces FS-5L Orange FS-1 + More

Need a micro latching switch for your amp, but your amp's footswitch doesn't have an LED, or you're not sure if your amp provides power for an LED? You're covered.

The Saturnworks single footswitch amp/device switch replaces the Marshall P801, the Boss FS-5L, the JHS Red Remote -- and a variety of other simple latching applications. This switch also works with any device or application applications that requires a basic TS on/off (open/ground) latching footswitch.

Unlike basic latching switches, this switch features an externally powered LED. This means you can see at a glance what state your amp or device is in. Not sure if your device provides power for an LED on a remote footswitch? No problem. The external power has you covered. And its extremely low power consumption (around 2mA) means you can daisy chain it from about any other pedal, so that it doesn't use up an extra DC plug.

Please note, if your amp or device provides power for an LED, check out our Saturnworks amp switch with an internally powered LED. If the factory switch has an LED, but has no external power jack, it likely is internally powered.

Some amps and devices switch the LED on when the circuit is open, while others switch the LED on when the circuit is closed (grounded). Not sure which configuration your amp or devices uses? No problem. The toggle switch lets you change the LED's polarity; so it will work with either configuration.

For a demo on how the LED polarity switch works, check out the attached demo video a customer made of his latching LED polarity switch. The Saturnworks switch helped him to solve his 'problem' with an Orange amp--that with the factory footswitch, the effect is ON when the LED is OFF.  Please note: the customer in the video's switch was a custom layout, but has exactly the same circuitry as the switch in this listing.

The external power combined with an LED polarity toggle means that this switch has you covered for virtually any latching switch application for which you want to add an LED.

The Saturnworks latching amp switch features boutique- level parts and features, including:

• A high quality footswitch. 
• A heavy duty Neutrik TS 1/4” jack. 
• A micro 2" x 2" (1590LB size) cast-aluminum enclosure. 
• A one-year limited warranty against parts and manufacturing defects. See saturnworkspedals.com for warranty terms and conditions.
• High quality wire made in the USA.
• Handcrafted and bench tested in California, USA. 
• A passive design means that the switch works without power. The power is only for the LED, which runs on standard (for pedals) 9v DC center-negative power. 
• A top quality Lumberg brand power jack.

Please note: The pedal in this listing is a stock image, not the actual pedal you will receive. The pedal you receive may vary in its graphic and/or LED color.

Check out saturnworkspedals.com for the full Saturnworks lineup.