A-101-6 is a new filter module that uses so-called opto FETs to control the filter frequency. Opto FETs are very similar to Vactrols but use light depending field effect transistors (FETs) instead of light depending resistors (LDRs). A opto FET is a combination of a light depending FET and a LED (light emitting diode) both put into a small light-proof case. The advantage compared to vactrols is the much faster response of opto FETs compared to LDRs. This allows much faster attack/decay times and even FM effects. The disadvantage compared to vactrols is that the FET behaves as a normal Ohm resistor only for small levels. With higher levels the FET begins to distort. Apart from this the notes mentioned on the Vactrol Basics page are valid.

Module A-101-6 is made of six serial 6dB filter stages. Each stage can work as lowpass, highpass or one of two allpass types.
The brightness of the Opto FET LEDs and consequently the filter frequency can be adjusted manually (Frequ. control) and controlled by means of an external control voltage (CV) with attenuator. The LED at the front panel reflects the LED brightness inside the opto FETs. 

The resonance is controlled by the Feedback control up to self oscillation. By means of a trimming potentiometer the maximal feedback can be adjusted. High feedback values can be used mainly in the allpass mode to obtain very extreme self oscillation sounds. Even an external feedback signal can be used instead of the internal feedback connection (FB In socket). Whenever the filter type is changed by means of the jumpers the trimming potentiometer for the maximal feedback has to be re-adjusted.

The Mix control is used to pan between the original signal (CCW position) and the effect signal (CW position). In filter mode (LP/HP) this control is usually set fully CW. In the allpass modes one obtains phasing sounds at center position or "pure" allpass sound in fully CW position.

Features

  • Optical Voltage Controlled Filter using opto FET's 
  • Low-Pass, Band-Pass, High-Pass, and All-Pass filter slopes available
  • Circuit board jumpers for altering configuration and filter slope
  • Faster response than vatrols which allows for quick vc response and FM capabilities
  • Feedback chain can be variable and repatched for strange resonance effects

Product Specs

Condition:
Brand New (New)
Brand
Doepfer
Model
A-101-6 Opto FET Filter / Phaser
Categories
Eurorack

About The Seller

Perfect Circuit
Joined Jul 2015
Burbank, CA, United States

Quick
Shipper

Accepted Payment Methods

Shipping Policy

Available for local pickup from Burbank, CA, United States

Ships from Burbank, CA, United States to:

Continental U.S.
$0.00
Asia
$39.99
European Union
$49.99
Australia
$44.99
France
$39.99
Germany
$39.99
United Kingdom
$39.99

All orders over $100 will ship for free to the lower 48 states.
International shipping prices will be calculated.

Tax Policies

CA, US
10.25%
United States - WA, MN
Tax is calculated at checkout. Learn about why tax is required in this region.

Return Policy

Return Window

This product can be returned within 30 days of receipt.

General Terms

Items must be returned in original, as-shipped condition with all original packaging and no signs of use. Buyer assumes responsibility for all return shipping costs unless the item was not received as described.

Refunds

Buyer receives a full refund in their original payment method less any shipping costs and a 15% restocking fee.

Special Conditions

Please see our full return policy here: https://www.perfectcircuit.com/return-policy

Message Seller

Accepted Payment Methods

Credit Card
Reverb Bucks
Paypal

Perfect Circuit

Burbank, CA, United States
Joined: Jul 2015

Seller Achievements

Doepfer A-101-6 Opto FET Filter / Phaser
$135
+ Free Shipping