Module A-160-2 is an enhanced version of the standard clock divider A-160. The module is a frequency divider for clock/trigger/gate signals, designed to be a source of lower frequencies, particularly for rhythm uses. The Clock input will take any digital signal from, eg., an LFO, MIDI sync, or the gate from a MIDI-CV interface. At the outputs, you have access to three sets of seven different sub-divided clock signals, from half the clock frequency down to 1/128. The low/high levels of the output signals are 0V and about +10V.

The A-160-2 also has a reset input. Whenever a reset signal is sensed, all outputs are set to certain levels which depend upon the selected mode.

These are the most important features of the module:
Three different sets of dividing factors, selected by a three-position switch at the front panel:

  • power of two: 2, 4, 8, 16, 32, 64, 128
  • prime numbers: 2, 3, 5, 7, 11, 13, 17
  • integer: 2, 3, 4, 5, 6, 7, 8

Two output modes, selected by a two-position switch at the front panel:

  • Gate mode: outputs act like the outputs of typical binary dividers
  • Trigger mode: in this mode the outputs are AND-wired with the clock signal (i.e. the clock pulsewidth affects the pulsewidth of the outputs)

Clock edge type selected by a jumper on the pc board:

  • positive: the rising edge of the clock signal triggers the state change of the outputs
  • negative: the falling edge of the clock signal triggers the state change of the outputs

Reset behaviour by two jumpers on the pc board:

  • level triggered: the level at the Reset input triggers the Reset
  • edge triggered: the edge of the signal at the Reset input triggers the Reset
  • positive: a high level (> 2.5V) or the rising edge at the Reset input triggers the Reset
  • negative: a low level (< 1 V) or the falling edge at the Reset input triggers the Reset

Output polarity selected by a jumper on the pc board:

  • positive: non-inverted outputs
  • negative: all seven outputs are inverted

Specs:

  • Width: 4 TE / 4 HP / 20.0 mm
  • Depth: 35 mm (measured from the rear side of the front panel)
  • Current: +50mA (+12V) / -0mA (-12V)

Product Specs

Condition:
Brand New (New)
Brand
Doepfer
Model
Doepfer A-160-2 Eurorack Clock Divider II Module
Categories
Eurorack

About The Seller

Signal Sounds
Joined Feb 2017
Glasgow, United Kingdom

Accepted Payment Methods

  • PayPal

Shipping Policy

Available for local pickup from Glasgow, United Kingdom

Ships from Glasgow, United Kingdom to:

United Kingdom
$0.00
European Union
$10.60
North America
$18.54
Everywhere Else
$21.19

We use a combination of Royal Mail, UPS, DPD and Fedex depending on where you are in the world and the value of your order.

Anything over £50 is normally sent by a Tracked service.

Tax Policies

United States - WA
Tax is calculated at checkout. Learn about why tax is required in this region.

Return Policy

Return Window

This product can be returned within 14 days of receipt.

General Terms

Items must be returned in original, as-shipped condition with all original packaging and no signs of use. Buyer assumes responsibility for all return shipping costs unless the item was not received as described.

Refunds

Buyer receives a full refund in their original payment method less any shipping costs.

Message Seller

Accepted Payment Methods

Checkout via PayPal
Use a PayPal account or Credit Card

Signal Sounds

Glasgow, United Kingdom
Joined: Feb 2017

Seller Achievements

Doepfer A-160-2 Eurorack Clock Divider II Module
$117.89
+ $18.54 Shipping