Here is a highly sought after Peavey Tubefex Midi Tube Guitar Preamp Digital Effects Processor in great condition. New battery just installed. Version 1.5 firmware. Here’s more info for those who are interested.
The Peavey Tube Fex as the name implies is a tube/valve and effects preamp. It features two 12AX7(ECC83) tubes/valves. The unit is stereo both XLR outputs as well as quarter-inch outputs. It features a buffered stereo effects loop. There is also Midi in, out, and Thru. The Midi in jack can use both a 5 pin midi cable as well as a 8 pin midi cable. The 8 pin serves as a two way communications between the amp and the Peavey FPC 10 (not included). As well as, providing that foot controller with power. It has your conventional digital effects: Reverb, modulation, delay, overdrive, distortion, noise gate, Exciter, speaker simulation, coil-tap sim, Envelope filter, compressor, eqs, and pitch shifters. With the effects there is also the spiltter to divide up the signal chain. As well as ways to run effects in series, parallel, or a combination of both.
At the front of the unit going from left to right is a input jack for your guitar, fx send, or etc. Then there are five knobs. Those knobs are as follows, Pregain, Bass, Mid Treble. They operate as the global controls and the preset and tube mode controls. Next, is a two line illuminated display for displaying the user interface, settings and info. Afterwards, there are the buttons for changing presets, settings, modes, and global parameters. There is a ram cartridge that accepts battery backup ram cartridges that were the standard a the time. The finally there is the power switch. Some like it better than the ADA MP1 and Marshall JMP-1and Rocktron Pirana or Prophecy.
The Peavey Tube Fex as the name implies is a tube/valve and effects preamp. It features two 12AX7(ECC83) tubes/valves. The unit is stereo both XLR outputs as well as quarter-inch outputs. It features a buffered stereo effects loop. There is also Midi in, out, and Thru. The Midi in jack can use both a 5 pin midi cable as well as a 8 pin midi cable. The 8 pin serves as a two way communications between the amp and the Peavey FPC 10 (not included). As well as, providing that foot controller with power. It has your conventional digital effects: Reverb, modulation, delay, overdrive, distortion, noise gate, Exciter, speaker simulation, coil-tap sim, Envelope filter, compressor, eqs, and pitch shifters. With the effects there is also the spiltter to divide up the signal chain. As well as ways to run effects in series, parallel, or a combination of both.
At the front of the unit going from left to right is a input jack for your guitar, fx send, or etc. Then there are five knobs. Those knobs are as follows, Pregain, Bass, Mid Treble. They operate as the global controls and the preset and tube mode controls. Next, is a two line illuminated display for displaying the user interface, settings and info. Afterwards, there are the buttons for changing presets, settings, modes, and global parameters. There is a ram cartridge that accepts battery backup ram cartridges that were the standard a the time. The finally there is the power switch. Some like it better than the ADA MP1 and Marshall JMP-1and Rocktron Pirana or Prophecy.
| Listed | 8 years ago |
|---|---|
| Condition | Very Good (Used) Very Good items may show a few slight marks or scratches but are fully functional and in overall great shape.Learn more |
| Brand | |
| Model |
|
| Categories | |
| Made In |
|
Product safety information may be available here.












