Acoustic Image Clarus Series 4

This amp is mint! New, you'll pay just under $1,000. This one has everything included from when it was purchased new. Here's the lowdown on this amazing amp:

The two-channel, Series 4PLUS Clarus has two separate channels which can be used to blend two sources - two different pickups or mics (or a combination of the two), or two different instruments. The XLR and ¼" inputs are on separate jacks. Additionally, they are separately buffered, which means that you could effectively use both at once, on each channel. You would only have independent control if at least one of those sources had its own volume control (like a keyboard, or an instrument with an outboard active preamp) but it does open up the possibility of actually "mixing" up.

The preamp features a new four-channel equalizer, as follows:

• Low: Shelving, ±12dB at 50Hz
• Lo Mid: ±12dB at 250 Hz
• Hi Mid: ±12dB at 1200 Hz
• Treble: Shelving, ±12dB at 8 kHz

The built-in Digital Effects can be assigned to either channel (or both/neither), and the amount of the effects in your mixed signal can be adjusted with the level knob. The rate setting is now configurable (!) and the effects include the following presets:

• Reverb
• Delay
• Reverb PLUS Delay

One last new feature - illuminated on/off buttons for the front panel controls to indicate whether the button is on (lit) or off (unlit). This is really helpful on a dark stage!

Features:

• 1/4" or XLR input; input impedances are 1 megohm or 600 ohms based on jack chosen, separately buffered
• Switchable 48 volt phantom power to XLR input jack
• Switchable 10db cut filter (Mic Attenuation) on XLR input jack
• Effects Loops via 1/4" phone jacks for each channel
• Low Cut Filter: -12 dB/octave sweepable from 30-150 Hz
• Switchable limiter for high volume situations
• Headphone output
• Balanced XLR Line Output with Ground Lift
• PRE- or POST- switch for XLR output
• AC Power On/Off switch with LED Indicator
• 650-Watt (@4 ohms) "Digital" Power Amplifier -- (650w @4 ohms, 350w @8 ohms - 2 ohms minimum load)
• 2 External Speaker Outputs (Neutrik Speakon)
• Detachable AC Input Connector with Built-in Fuse
• Dual voltage operation (115v/230v, 50/60 Hz) via automatic switch (comes with USA Cable; to use in other countries, you can source an IEC-C13 AC Cable, also commonly used for computer power supplies.)
• Comes with Speakon to 1/4 inch adaptor