Toronto, Kanada
Zu diesem Inserat
The XLi 800 is a two-channel power amplifier from the Crown XLi series for musicians, DJs and entertainers, and for houses of worship, clubs and pubs. It delivers 300W per channel into 4 ohms, 200W per channel into 8 ohms and 600W into 8 ohms in bridge-mono mode.XLR and RCA inputs take mixers and consumer sources, and the input sensitivity switches between 0.775V and 1.4V. Speakers connect by Speakon or binding posts. The four XLi models share the same features at different power ratings.Features
Stereo, parallel and bridge-mono modes
Switchable input sensitivity: 0.775V or 1.4V
Balanced XLR inputs and RCA inputs
Speakon and binding post outputs
Two level controls, a power switch, a power LED, and signal, clip and fault LEDs for each channel
Forced-air cooling
Protection against shorts, no-load operation, on/off thumps and radio-frequency interference
Specifications
Channels: 2
Rated output power: 300W per channel at 4 ohms, 200W per channel at 8 ohms, 600W bridged at 8 ohms
Input sensitivity: 0.775V or 1.4V for full rated power at 8 ohms
Signal-to-noise ratio: More than 100 dB (A-weighted)
THD: Less than 0.5%, 20 Hz to 20 kHz
Intermodulation distortion: Less than 0.35% (60 Hz and 7 kHz at 4:1, full rated output to -30 dB)
Frequency response: 20 Hz to 20 kHz, +0 dB, -1 dB (at 1W)
Damping factor: More than 200 (8 ohms, 10 Hz to 400 Hz)
Input impedance: 20k ohms balanced, 10k ohms unbalanced
Voltage gain: 29 dB
Slew rate: More than 10V/µs
Inputs: Balanced XLR, RCA
Outputs: Speakon and binding posts
Cooling: Forced air
Power connector: 15A IEC
Dimensions (W x H x D): 19 x 3.5 x 12.4 in. (48.3 x 8.9 x 31.5 cm)
Weight: 25.1 lb (11.4 kg)
PreisC$599.99
14 Tage Rückgaberecht
Genieße Sorgenfreiheit mit deinem neuen Equipment




