Advanced Audio Designs Model 101 “Guitarist” Pre Amp (Late 70’s)

Advanced Audio Design’s Model 101 

-Late 70’s Guitar Pre Amp

-Alex Liefson of Rush  

-Clean To Crunch 

-Take’s FX well

-If your into funk,pop,post punk,jazz,r&b, or country “chicken pickin’ / Pedal Steel, then this is a GREAT pre amp

-This pre amp would be VERY useful for a studio looking for a unique guitar sound particularly for the aforementioned styles    

• Input - Two series connected pre-amps to control stage gain & overdrive characteristics.
• Equalization - Low, Mid & Hi EQ with +/-15dB boost & cut, switch selectable center frequencies, Hi 4K/3K, Mid 2K/1K, Low 250/125Hz.
• Frequency Response - +/- 1.5dB, EQ set flat pre-amp set for no distortion. 30Hz-22KHz at 2 volts out.
• Hum & Noise Level - 70 dB below rated output.
• Rated Output - 2 Volts RMS into 500 ohms or higher.
• Distortion (THS) - .01% Harmonic minimum, 85% Harmonic maximum dependent on pre-amp control settings.
• Output - Low impedance Balanced, Line level Unbalanced.
• Circuitry - Low noise, fully solid state.
• All components are under-rated for long trouble free life.
• Dimensions - 1 3/4 inches high by 19 inch standard 1U rack front panel. 8 1/8 inches deep.
• Weight - 8.3 lbs.