DPA 4006 Omni Mic - Stereo Kit - Used

DPA 4006 Omni Mic - Stereo Kit - Used

The DPA ST4006 is a stereo matched pair of high quality onmi-directional condenser microphones contained in a hard-wearing, road ready Samsonite case.

These are used microphones. They are in very good condition with some signs of use. Please see images.

With two precisely matched capsules, the DPA reference standard tolerances are increased even further to perfectly pair both mics to each other. Ideal for drum overheads, choirs, pianos, harps and other dynamic and varied sound sources, the 4006As offer clear, transparent sound on whatever source they capture. High SPL handling, low noise-floor, linear frequency response makes the pair perfect for AB stereo recordings, and the omni pick up pattern allows extra close mic positioning without suffering from the proximity bass boost effect.

The pair comes encased in a solid Samsonite case for transportation, and all relevant clips and windscreens are included.

DPA ST4006 Stereo Pair Features

• Carefully matched microphones
• High sensitivity, low noise-floor and extremely linear frequency
• Samsonite case transportation and protection microphones

Specifications

• Directional pattern: Omnidirectional
• Principle of operation: Pressure
• Cartridge type: Pre-polarized condenser
• Frequency range: 10 Hz - 20 kHz
• Frequency range, ± 2 dB: 10 Hz - 20 kHz
• Sensitivity, nominal, ± 2 dB at 250 Hz: 40 mV/Pa; -28 dB re. 1 V/Pa
• Equivalent noise level, A-weighted: Typ. 15 dB(A) re. 20 µPa (max. 17 dB(A))
• Equivalent noise level, ITU-R BS.468-4: Typ. 27 dB (max. 29 dB)
• S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 79 dB(A)
• Total Harmonic Distortion (THD): < 1 % up to 139 dB SPL peak
• Dynamic range: Typ. 124 dB
• Max. SPL, peak before clipping: 147 dB
• Switchable attenuator: 0 dB / -20 dB
• Output impedance: < 200 ohm
• Minimum load impedance: 2 kohm
• Cable drive capability: 100 m (328 ft)
• Output balance principle: Impedance balancing with Active Drive
• Common Mode Rejection Ratio (CMRR): > 60 dB
• Power supply (for full specifications): 48 V Phantom power (± 4 V)
• Current consumption: 2.8 mA
• Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
• Color: Matte black
• Weight: 163 g (5.7 oz)
• Microphone diameter: 16 - 19 mm (0.6 - 0.75 in)
• Capsule diameter: 16 mm (0.6 in)
• Microphone length: 170 mm (6.7 in)
• Output voltage, RMS: > 5 V
• Polarity: +V at pin 2 for positive sound pressure
• Temperature range: -40 °C to 50 °C (-40 °F to 122 °F)
• Relative Humidity (RH): Up to 90%
• Classification: Conforms to IEC 61672 Class I (with Near-field Grid DD0251)
• Matching tolerance: ± 0.5 dB
• Phase deviation for kit: < 5°