Headphone / Preamp Pedal

Paladin Preamp/Headphone Amp Pedal by Fearsome Sound

Preamp’s input is designed to accept your instrument or pedalboard signal chain output. If your signal is a little hot or cold, you can pad the signal up or down with Preamp’s input level control.

Three independent, level controlled outputs are provided:

Headphone Out - Two channel MONO output designed to drive 4 to 32 ohm stereo or mono headphones. Over the ear models perform best.

Unbalanced Out - low impedance output designed to drive an instrument amplifier or the unbalanced input of an audio board or computer recording interface.

Balanced out - low impedance output Tip, Ring Sleeve (TRS) designed to drive a balanced audio board input or computer recording interface.

The Tone Stack

The active tone stack provides control of treble and bass boost and cut for all three outputs. The Tone Stack has essentially no effect on your signal when the controls are in the 12 o’clock position. 

The Enclosure

Paladin Preamp is housed in a Hammond 1550C cast aluminum enclosure. Dimensions are stompbox typical: Length 115mm (4.53in) x Width 90.0mm (3.54in) x Height 55.2 mm (2.17in).

The Power Supply

Paladin Preamp requires a typical Stompbox 9vdc, Center Negative PSU. Preamp is not battery powered.

Fearsome Sound is located in Woodstock, New Brunswick, Canada. Contact us through the Fearsome Sound web page. Listen to audio clips of Fearsome Sound pedals on the Media page.

See, try and buy all Fearsome Sound pedals at Tony's Music Box in Fredericton New Brunswick.