Prewired Precision Bass Wiring Harness - CTS, Sprague - Wainwright Customs

Upgrade your tone, and replace those scratchy pots!

These are brand new USA-Spec pre-wired wiring harnesses for P-Bass. I hand-wire these with all new parts, including an upgraded Orange Drop tone cap, treble bleed circuit, and waxed cotton wire.

Satisfaction guaranteed, or send it back for a full refund.

Each assembly is shipped pre-wired and fully assembled, and includes the following:

• (2) CTS USA 250k Ohm Solid-Shaft Pots (Split shaft CTS or Bourns available upon request.)
• (1) USA 1/4" Output Jack (Switchcraft or GLS)
  
• (1) 0.047uF Orange Drop Tone Capacitor (also have darker caps - 0.056, 0.068, etc.)
• Waxed Cotton Push-Back Wire

Will this fit my Squier or other Asian Import Bass?
Yes, this will fit your Squier or other import P-Bass, however you will need to drill the pot mounting holes to 3/8" on your pickguard. Your Squier may also have push-on knobs, and this will require USA-spec 1/4" solid-shaft/set-screw knobs. Alternately, see my other listings for an import-spec version.

Note: These are short-shaft pots, designed for mounting on a pickguard. If you are intending to install this on a bass with rear-mounted controls that go through the wood top of the instrument, you need to LET ME KNOW, so that I can use longer-shaft pots instead. 

Looking for a custom built harness?  See my other listings for a "Made to Order" custom option, built to your specs.