Perth Amboy, NJ, United States
About this listing
Up for grabs is a lightly used Marshall MS-2, 1-watt (1W) battery powered Micro Stack Portable Amp - Black. 9V Battery Included. It can also be powered with adapter (adapter NOT included). MISSING the original battery cover. I don't have any NON-original battery covers that are an exact fit to completely close by snapping in shut. But I have two battery covers that are almsot the same style - but they do NOT snap in to completely shut. I can include both of them. Feel free to ask for pictures. When I have a chance - I add a picture of them in this listing.===CONTROLS (three knobs): 1) Volume, 2) Tone, and 3) Off, On (which is CLEAN), or OD (overdrive)Measurements: H: 5.51" W: 4.33" D: 2.36"==1/4" Input Jack (to connect to your guitar or bass ...)1/4" output jack for HeadphoneBelt Clip. ==The adapteris NOT included. The Marshall MS-2 Micro Amp requires a 9V DC adapter with a 2.1mm barrel connector, negative center, minimum of 200mA. NOTE: You can use an adapter that is higher then 200 mA (for example: 500mA, 1700mA) and the unit will draw what it needs.TECH SPECS are further down in the description.===Product info from the Marshall website: Portable amplifier - small but mighty. These 1W micro amps may be small but deliver the true Marshall tone. Rock out wherever you are, whether you're in your bedroom or on-the-go.Life in miniatureDon’t let their size fool you, these small but feisty 1W micro amps deliver the true Marshall tone in our most portable format. As they’re battery-powered, you can attach them to yourself using the belt clip and play on the move, or practice in your bedroom by plugging into the mains. Our micro amps really do prove that size isn’t everything. Designed and engineered in UK. Made in Vietnam.===This micro amp was tested and works fine. As mentioned above and as seen in some of the pictures - this item is MISSING the Battery Cover. But the battery stays in the battery compartment fine (fits in it tightly / very snug).NOTE: Even though the Marshall product info above states it is "small but mighty" - it is a simple relatively small basic 1 watt amp. So it is not going to be extremely loud. You know what I mean.Even though the battery cover is MISSING - this micro amp holds the battery tightly inside the battery compartment. If you ae using this micro amp with a battery and have it on a table or on the floor, etc - it will be OK without the battery cover. If you are going to use it with the BELT Clip and stand, wlak around, and / or jump around - they you might want to place tape over the battery compartment (but it might not be necessary - see how it goes and then decide what you want to do). NOTE: If you plan to use this micro amp frequently- I would recommed that you power it with an adapter because it will drain your 9v battery kind of fast.NOTE: I'm not the original owner of this micro amp he previous owned did place tape over the battey compartment. There was some residue (from the tape) on the back side of the micro amp. I CLEANED OFF practiall all of THIS RESIDUE. But there are a few very tiny & very small not soo noticeable spots. I also went over some of the back side (where I cleaned of the residue) with black shoe polish. So the lower half of the back side is slightly shinier than the upper half.The gold colored panel on the front side (where the knobs are) has a couple of very light hait-line surface scratches.The black ribbon like material in the battery compartment has some residue on it.I took pictures of all sides of this micro amp. Feel free to ask for more pictures.NOTE: There may be a few imperfections that I overlooked. There may be a couple of not too seriouss imperfections that can be seen in person that do not show up in the pictures. And - there are some glares, reflections, and / or dust specks show up in the pictures that are not visible in person.==MORE Product Information:The MS-2 is a 1W (1 watt) micro stack that may be small but will deliver the true Marshall tone. Powered either one 9V battery (included) or a by adapter NOT (included). It’s versatile enough to play on the move (it has a belt clip) or practice in your bedroom. The MS-2 features volume, tone and overdrive controls. The color of the micro amp for sale in this listing is Black.Designed and engineered in UK. Made in Vietnam.Tech Specs:Type: Solid StateNumber of Channels: 2 (split) Clean and ODOutput Power: 1W (1 watt)Speakers: 1 x SpeakerEQ: 1-bandINPUT: 1 x 1/4" instrument jackInputsOUTPUT: 1 x 1/4" headphone jackCONTROLS (three knobs): 1) Volume, 2) Tone, and 3) Off, On (which is CLEAN), or OD (overdrive)Belt ClipHeight: 5.51" (140 mm)Width: 4.33" (110 mm)Depth: 2.36" (60 mm)Weight: 0.75 lbs (0.34 kg) Manufacturer Part Number: MS-2===Comes from a smoke free and pet free environment.Feel free to ask questions.Will discount shipping on combined purchases!!USA Shipping is with USPS (with tracking). International Shipping is with First Class Mail International (with tracking).CA Prop 65 Warning!!Everything sold into the state of California contains agents known to the state of California to cause cancer and birth defects, reproductive harm, or other, as yet unnamed, harm to its citizenry.
Original PriceA$56.24
14% price drop
New PriceA$48.84
+ A$72.54 Shipping
